Questions & Answers for: primer and cap

...primer fuel cap for my (Textron) Homelite Little Red XL chainsaw, UT 10741 I have a Homelite Super 2 chainsaw that has a hole in the primer bulb on the fuel cap...will not prime. Where can I find a ...

...cap is opened it sprays gas and primer will not fill withgas The tank vent is a bronze plug inserted into the tank casting--the caps are not intended to vent. Check the fuel filter for plugging and ...

...cap and could this be why I can't get suction from the primer bulb? You may be overfilling the tank somewhat so that expanding fuel (from engine heat) is being pushed out of the vent. Check the fuel ...

...have the same problems. it should have a small vent in the fule tank cap if its blocked the primer bulb will be sucked in as the fule pump can **** any fule from the tank check the tank cap

primer) something possibly dirt is holding it down or try loosening gas cap and see if it pops back up and works right, if so your vent in gas cap is not working, if thats not it time for a carb clean

...cap primer bulb (The primer bulb is built into the fuel cap) for a Homelite Super 2 UT10696C1 You can order the fuel cap on the link below. ...

...in primer Replaced fuel line to tank. No problems before. No fuel in primer unless I lay chainsaw on side with filler cap up. Possible filler cap bad? did you forget to install the filter on the

cap on the tank pump the primer button to build pressure in the tank and then turn the cap a turn or so and hear the pressure release. If that is all ok then I would think the diaphragm in the carb is

...primer bulb connected to the gas cap. So,,,,, I'm hoping you're asking two questions at the same time. 1) Primer bulbs are replaceable but it's extremely rare that it is necessary 2) Gas caps are ...

...gets in it creates a vacuum causing the primer to collapse and will shut down the engine. If there is no vent turn the cap open a little just to let some air in but those tanks should be able to