...pico fuses. the look like small like resistors. i have seen them all white, all yellow, & all green. if you find them they are usually marke in amps, so replace with the same amp pico fuse. good ...
...pico fuse. I have the service manual and have found the schematics and picture of the board but I dont know how to identify the pico fuses and am unsure how to test them with a meter. And as far as ...
...pico fuses look simular to resistors but are a solid color and has the value writen on it. the component location will start with "F" (Fxxx) or in some cases "PR" (PRxxx). F stands for Fuse and PR ...
pico fuses are these situated on the power board or the board with the ircs on what does a capacitor look like a resistor look like how many pico fuses are there IDing components of electronics is ...
are replaced should it line up the blue still dose not want too work You need to check the area for pico fuses or low valued reistors. When the ICs go bad, they often will smoke the resistors or fuses
Question about PT-53WX53 53" Rear Projection HDTV-Ready Television
pico fuse i was wondering if someone could tell me in relation on the board like r7011 u know to find the pico fuse thank u R7080 is mounted parallel with Transistor Q7060 (base-emitter) supplying +20
Question about PT-47X54 47" Rear Projection HDTV-Ready Television
...SOLUTION You will need to replace the convergence chips and possibly some convergence resistors and pico fuses. Its a fairly easy DIY job or you can call in a pro. If you want to do the repair ...
Question about PT-45LC12 45" Rear Projection HDTV-Ready Television
...to repalce with a normal 5amp fuse. Just clip it out and solder the new one in. I would use a pico fuse. Or invest in a replacement thermal fuse from a part store. Part number K5C117BC0003.
...are white in color then they are called ceramic fuses, but still have an amp rating. If they are Pico fuses they also have ratings that are close to their location on the board. DO NOT go above
Question about PT-53WX42 53" Rear Projection Television
...pico fuse around the convergence board,must used a Ohm meter test all of those resistors torlerance and the pico fuse changes those resistors are not have the wright tolorance of it colors bands on ...
Usually answered in minutes!
627 Questions
462 Questions
520 Questions
406 Questions
457 Questions