Questions & Answers for: parts tb70ss troy bilt weed

...Troy Bilt weed eater and am having a problem. It starts with the choke on, but it will not run with the choke off. Ths problem is possibly indicating the need for a new fuel pump diaghram in the Zama ...

...troy built weedeater has run fine but all of a sudden it quit. I can crank it, and it will idle, as soon as I give it gas it shuts down. I have tried cleaning the carb, and screen on the muffler but ...

...TB70SS) would not run. I bought new spark plug and it ran great for half an hour. It stopped running and would not start again. I noticed that the new plug looked like it had oil all over it. I took ...

...parts near the bump knob are worn down enough to make this happen. Any ideas would be appreciated! Take the shaft off at the motor,see if any thing is worn there.Also,take head off of end of weed ...

...Troy built 70ss gas engine. Installed gaskets but no results. Weedeater runs while choke is on, then runs for five seconds after choke and dies. Seat and needle were not replaced. Would that make a ...

...tb70ss model troy built weed eater came off and the heat build up and centrifical force caused the spool to melt and become distorted. I replaced both plus the inner reel but it occurred again after ...

...weed eater on the choke position and stays idle although it should not. I move the lever to position 2 and the 3 and the engine runs at the same speed. If I accelerate, the engine dies... Help! Check ...

...weed eater started but only at a idle, and when it is idling it spits gas out the carburetor and runs down onto the muffler and i mean spits alot of gas. will not high idle and i have replace most of ...

Weed eater starts easy, lots of smoke when idling, dies after you accelerate once of twice. New spark plug, cleaned air filter and replaced the fuel??? Any guesses? Hi Sounds like you have dirt/debris