...i look for to be wrong with them? hi your assumption is wrong the light blinks for meny diffrent reasons: 1) power is too low - check the battery of the car 2) connections are wrong 3) the AMP ...
Station Tunning I want to learn how to tune stations in manually, I can scan through stations but I need to change stations by 0.1 to tune in other audio equipment. iv'e never seen a radio that can ...
DVD will not show picture I have sound, but no picture...what can I do? No activaste por equivocacion la funcion PROGRESIVE SCAN s i lo hiciste desactivala,no cambiaste el formato PAL o NT SC.
Question about ProTalk TK-3200U8P (8 Channels) 2-Way Radio
...scanning, press the Scan key. ? The LED indicator flashes green and scanning starts from the current channel and ascends through the channel numbers. ? When a signal is detected on a channel and
kenwood tk-840 programing software , where to get it and alittle info on the uhf The only legal way you can get the software is to buy the software from Kenwood or one of its dealers. Since the radio ...
How do u eneter the code to the cd player,and nt have 2 put the code in every time you start the ignition? is the yellow wire going to a constant power source?
TK 760 scanning delay I have a mobile TK760HG and it takes forever before it stops scanning and lands on an active transmission. Most transmissions are done before the radio goes to that channel Hi ...
the the 28 permanently scanning You can disable scanning from programming. you put cursor at 28 and dubble click and see feature of scanning. disable it.
Question about Tk790 Tk780 Tk730 Tk830 Mobile Radio Jotto Faceplate Face Plate 01
only scans on monitor Check the programming. I don't know what term they use, but on hook, or off hook scan enable/disable is something to look for in the programming. This is often in a sub menu ...
Question about Tk790 Tk780 Tk730 Tk830 Mobile Radio Jotto Faceplate Face Plate 01
how do i get my tk -760 hg to scan the channels Your microphone must be grounded properly. The mic hang up clip must be grounded. Then, if the programer enabled scan, you press the scan button. Lots ...
Usually answered in minutes!
202 Questions
203 Questions
165 Questions
142 Questions
149 Questions