Questions & Answers for: Chevrolet Cobalt need switch

...switch Need to know how to replace lock switch, can't get old one removed, do i need to take off door panels or is there an easier way? There's an easier way. I can only answer for the coupe though. ...

need a ignition switch.Here is the good news,All the the cobalt has a failed ignition switch and Chevy has published a TSB bulletin for their failed ignition switch.Bulletin No. 09-02-35-005C.(Febuary

...need to know is how to change the switch? Good day; The following is the removal of the switch 1. remove the steering column trim covers. 2. disconnect the ignition switch harness connector. 3. turn ...

...need to be more specific, if everythings working? why doesnt the window work? do you mean all the other windows work? does it work using the pass window switch? master (drivers) window switch? is the ...

need a new ignition switch. Disconnect the negative cable to the battery and that should stop the engine. Then you need to get the ignition switch by removing the lower steering column cover to access

key out when it is in park what i the problem you need to check and see if the park switch is activated to allow the key to be removed, if switch is ok then ign, lock cylinder will need to be replaced

...switch is bad the shift lever will not lock in park and the key will not come out.will the key turn? can you start the engine?the colbalt has had bad ignition kock cylinders and park switches.need to ...

...need replaced. Only try to do this if you have patience since once the electrical switch is unbolted you will have to readjust when reinstalling and if you have never done this it can take some

...need to check carefully the voltages at the stop lamp switch and its on/off function. If voltage is not present at the stoplamp switch, you can check the C4 connector(light gray in color) at the BCM ...

...switch you may need to turn the key a little while pulling off the switch  assemble opposite way they you will need learn the new switch to the system you will need to cycle the switch to crank ...