...move panel lights up Does your L7 have error code that looks like L5 , but its really LS which mean lost signal. Unplug unit take motor shroud off then plug unit back in wall outlet. When looking in ...
...shroud and on top of drive motor it is attached to a bracket with 2 bolts. Unplug the unit and remove motor shroud see if you can adjust it first by loosen the 2 nuts and moving the sensor forward ...
Question about L7 LTD Executive Trainer Treadmill
...shroud and on top of drive motor it is attached to a bracket with 2 bolts. Unplug the unit and remove motor shroud see if you can adjust it first by loosen the 2 nuts and moving the sensor forward ...
treadmill does not start the screen is indicating "L5". i have tried unplugging and restarting, but unit does not move. please help. thx is a problem with the speed sensor or card connectors are ...
JKExer 8030 overspeed problem Only 8 months old, but is definetly not reading speed accurately. It doesn't skip, but has started going to fast for the speed shown on the panel. It happened after I ...
...L7 plugged in, and after pressing the start button, nothing lights up and the belt does not move. looking for a qualified technician to check the connectors on the lower board specifically where the ...
...Landice that has limited use. Condition is excellent. However, it exhibits intermitten belt actuation upon statrt-up. Specifically when the start button is activated it will initiate the motor, the ...
Question about L7 LTd Pro Sports Trainer Treadmill
i have a problem with the belt i dont know if it moved over to one side when i run on it it makes a crazy sound this happen because the lack of maintenace . Please LUBE the deck belt+ rollers bearing ...
...treadmill console. Replace any parts that need replacing, or move on to the next step. 2 Locate the reset switch on the underside of the treadmill console. Usually the button is large enough to ...
Question about L7 LTD Executive Trainer Treadmill
...Landice L7 treadmill and it will turn on and start moving all by itself without pressing start. Hello, it is either the control board or the overlay. I would think it is probably the start button on ...
Usually answered in minutes!
346 Questions
191 Questions
188 Questions
214 Questions
122 Questions