Questions & Answers for: Chevrolet Blazer motor cover

Question about 2000 Blazer

3 Answers

Motor is Behind the Cover. Remove the Wiring clip from this and Remove it. Take it down and get the New one. Goes on in Reverse. Let me know if you have any Problems! The blower motor is going bad. It

Ad

Question about 1996 Blazer

1 Answer

...cover not being on effect the functioning of the blower motor? If so, where am I supposed to get one to replace it? Like I said, there are no old blazers around here to get parts from. here is a ...

Ad

cover in the same manner. Remove the blower motor assembly. To install: Install the blower motor assembly. Connect the two halves of the access cover together using the three flange clips. Using black

Question about 1997 Blazer

1 Answer

cover Rear To Remove: Put the wiper arm in the park position. Remove or disconnect the following: The washer hose from the connector The cap from the wiper arm The nut from the wiper arm The wiper arm

Question about 1997 Blazer

1 Answer

...into the valve cover and it allows for proper ventilation to the bottom of motor. when one gets clogged,they tend to **** oil into the throttle body of the motor. thank you for choosing ...

...motor access cover screws. CAUTION Do not cut any deeper than necessary in order to remove the access cover. Cut through the access cover on the cut line using a sharp utility knife. Disconnect the ...

Question about 1996 Blazer

1 Answer

...4.3l Vortec motor, the pcv valve is located on the driver's side valve cover, near the center. If it is the 2.2l motor, it is also located on the main valve cover, near the front of the cylinder

Where is the windshield wiper motor relay located on a 97 chevy s10 blazer its located on the wiper motor.there a black removeable cover thats held on by some screws .remove that and it right there

Question about 1997 Blazer

1 Answer

...Blower Motor is on the passenger side fire wall.It is under a plastic cover that has to be cut with a razor blade.After motor is replaced plastic cover is sealed with a bead of weather ...

...drivers side windshield wiper arm from motor I did this yesterday.....There is a thin plastic cover over the nut, pry it off and you'll have access to the nut to remove the entire arm off the

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...