bad bearing in a model 395 front bearing is locked up on a model 395. were can I a repair shop? threw it in the trash!
...model 395 type5) has expired.Where can I get the part (home depot? ) or where? And is it hard to install ,what kind of tools to do the job, Are there diagrams on the internet to pool up? Definitely ...
...a manual for my dremel moto-tool model 395 thank you [email protected] dremel manuals are found here: http://www.dremel.com/en-us/CustomerService/ManualsAndLiterature/Pages/default.aspx enjoy. ...
Question about Variable - Speed Multipro Rotary Tool 395
...Model 395 The variable speed on my older model 395 only runs on high. I can not get it to run at any other speed. I have never replaced brushes or anything else on this Dremel. I'm assuming that this ...
Question about Variable - Speed Multipro Rotary Tool 395
...model 395 type 1 lock I am in need of a replacement collet lock spring ( includes lock and spring) You can either go to Dremel.com and type in your model number for replacement parts or call their ...
Question about 395 Variable Speed Multipro Rotary Tool Kit
...model 395 went dead after a total of 25hrs use over 3years I was routering a slot with my router Model 395 for the tambour door in the breadbox I am making for my daughter. The router went dead as if ...
...model 395? Remove the collet nut and collet then unscrew the sealing cap (black plastic ring), this has the same thread as the inner of the multi kit tool, so just screw on the tool then replace the ...
Question about 395 Variable Speed Multipro Rotary Tool Kit
Need a Flex coupling. part #529430970 for model 395 http://www.dremel.com/en-us/AttachmentsAndAccessories/Pages/Attachments.aspx
Question about 395 Variable Speed Multipro Rotary Tool Kit
Model 560. What does error code 062-395 indicate? http://www.manuals365.com/swf/fuji+xerox/ag-c560p_c550p.html?page=207 Fault Code 062-395: Scanner Power Cable Connection Fault.Sep. 21, 2015 Fault ...
Question about 395 Variable Speed Multipro Rotary Tool Kit
...Model category. The lock button should lock the shaft. With the collet facing you, turn anti-clockwise with grips or pliers. They should never be done up _that_ tight. Try spraying with penetrating ...
Usually answered in minutes!
191 Questions
163 Questions
151 Questions
96 Questions