Question about 30.1CC Chainsaw With a 14 In.bar and Chain
...low idle speed and the high operating speed turn the high speed and low speed mixture screws right in[gently]then out 2.5 turns.start it up,screw the idle screw up till it will idle,then adjust low ...
Question about Blowers Rake and Vac - Electric Blower/Vac - 51573
low speed screws? The high speed mixture screw is initially set at 1 & 1/2 turns out. Then adjust it to give good acceleration and top speed, while not closing the screw more than you need to. The
Question about Blowers Rake and Vac - Electric Blower/Vac - 51573
...low-speed jet. 5. Plugged low-speed jet. 6. Contaminated or plugged low-speed circuit. 7. Enrichner valve is not seated or leaking. For more information about your issue please visit the websites ...
...low-speed jet. 6. Plugged low-speed jet. 7. Contaminated or plugged low-speed circuit. 8. Enrichner valve/choke not seated or leaking. 9. Multi carburetors out of sync and need to be balanced. For ...
...LOW IDLE SPEED ITS SPITTING BIKE SPUTTERS, SPITS AT LOW IDLE SPEED carb out of adjustment Hi, Anonymous and the usual suspects are: 1. Idle speed improperly adjusted. 2. Inlet system air leak. 3. ...
Question about 2004 FXDL - FXDLI Dyna Low Rider
...low-speed jet. 5. Plugged low-speed jet. 6. Contaminated or plugged low-speed circuit. 7. Enrichner valve not seated or leaking. For more information about your issue please visit the websites below. ...
Question about 2004 FXDL - FXDLI Dyna Low Rider
...low-speed jet. 5. Plugged low-speed jet. 6. Contaminated or plugged low-speed circuit. 7. Enrichner valve is not seated or leaking. For more information about your issue and valuable "FREE" downloads ...
...low idle speed.. Then accelerate to highest speed and set the high adjustment for highest rpm. Then go from idle to high speed. If not smooth a small adjustment on the high speed screw is in order. ...
low speed screw and a idle screw attached to the throttle cable. Accelerates no problems, but idles to high. Idle screw adjusted as far as possible, low speed screw turned out 1 turn from seat. By the
Question about Pro 14" Gas Chainsaw 33CC P3314
...low speed mix and allow a couple minutes to warm. Then re-adjust low speed and lower idle rpms by turning out idle throttle speed screw. Then with throttle wide open adjust high speed mix. If saw ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions