Questions & Answers for: Honda Civic lock cover

...lock is stuck in, I can't pull it out. Is there a schematic that I can look at online to see how to get it out or is it in there with a pin or something. There are retaining screws around the handle ...

door locks I have a 2003 honda civic and the driver side door lock is broken. I want to change the passenger lock to the driver side lock. When I take the door apart I can't get the lock out, it's ...

...replaced Many Hondas have a lock by the Trunk release and fuel door release. If the lock is engaged, Pulling the gas cover switch will not open the door. Try using your key to unlock the switch

...as the cover will not close. You will have to replace the dust cover by removing the lock assembly. Sometimes, the entire lock assembly is replaced as the cover is crimped to the lock

1994 honda civic central locking problem my 1994 honda civic central locking is not working properly, when i open the drivers door using the key the other three doors does not open, when i push down ...

...lock on the passenger side door is pushed in so I cannot get the key into unlock it is there a way to fix this? Take Off Cover and Spray W40 On the Mecanism inside...Honda are bad for fusty Lock

...lights snap into place. Use a small screwdriver to gently push back the edges to locate a tab that locks the cover into the housing. Push back at the tab area until it pops out. Replace the bulb. ...

...lock switch connector (G). Remove the grip cover (A). To remove the passenger's grip cover, refer to rear door panel removal/installation. Using a trim tool, pry out the front edge of the cover to ...

...COVER.REMOVE THE IGNITION SWITCH.REMOVE THE RETAINING NUTS AND LOWER THE STEERING COLUMN.THE LOCK ASSEMBLY IS CLAMPED BY TWO SHEAR HEAD BOLTS.USE A CENTER PUNCH TO MAKE A DIMPLE IN THE HEAD OF EACH ...

...manage to remove. Maky thanks for any suggestion, because the trunk lid is somewhat loose when locked). Remove the plastic cover and you should be able to adjust the