Questions & Answers for: lock cover Cars & Trucks

Question about 1998 Grand Prix

1 Answer

...lock assy. so top plastic cover can be removed if you want to remove the plastic cover, look for some screws from the bottom part of that plastic cover. there are about 4 screws. you ,may need a long ...

Ad

Question about 2003 XC90

1 Answer

Cover lock The locking motor for the cover is not working correctly. If in the locked position (by hand) the motor unlocks correctly. This suggests the motor, wiring and any relevant fuse are ok. When

Ad

...cover to secure it but, It is not working or, I am not doing what is neccessary to lock it. What do need to do? Thanks, Lou from Palm Desert The normal operation is for the door to lock a several ...

Question about 2004 Murano

1 Answer

cover. Once you push the unlock button the lock inside will retract back allowing you to push on the cover. If you do have your doors unlocked, then it could be either the lock is not retracting as it

...cover for a I bought a replacement wire wheel cover for a missing one. However, my wheel cover locking key doesn't work on the replacement cover. Is there any way to secure the new cover? yes ...

Install a Ignition lock cylinder 1997 Pontiac Grand Am Ignition Removal Instructions Disconnect the negative battery cable from the battery. Refer to Battery Negative Cable Disconnection and ...

...as the cover will not close. You will have to replace the dust cover by removing the lock assembly. Sometimes, the entire lock assembly is replaced as the cover is crimped to the lock

Lock housing cover. Tip: To remove lock housing cover, gently pry between the locking pawl and cover guides while pulling down on cover. Underside of cover shown for case of location identification. A

Question about 1998 Contour

1 Answer

...in all positions. Reinstall the steering column covers. Reconnect the negative battery cable. Remove the three screws and remove the lower column cover Releasing the lock cylinder retaining ...

Question about 2004 Rendezvous

1 Answer

lock cylinder through the trim cover in the upper steering column. Align the lock cylinder retaining tab and the position tab with the slots in the lock housing. Completely push the lock cylinder into

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...