landice treadmill we have had a landice pro sport trainer treadmill for several years. today after running for 20 min. the safey screen appeared and the tread mill stropped moving. the magnet is on ...
Treadmill belt off center, it is positioned to one side I found two bolts at the rear of the treadmill that extended toward the tension bar. I felt they were the only way to adjust it. I had been too ...
Landice won't start, it gives a L 5 error. I already replaced both chip boards. but the light on the board closest to the motor does not come on! Not sure if I got a faulty board? Is there any ...
Landice 8 over speed protection I plug it into the wall, touch the start button and the belt starts moving very fast. The system shuts down and says over speed protection, shutdown. and then it is off
...moving the sensor forward without making contact to the flywheel, then tightened the nuts up. Plug the unit into the outlet, start the unit, if you still have the overspeed then replacement of the ...
Question about L7 LTd Pro Sports Trainer Treadmill
my landice 8 tradmill says safe and will not move 1) rUN THE SOFTWARE CALIBRATION for diagnose and troubleshootin.2) Lube the deck belt 3) Lube the rollers bearing4) Measure the input voltage motor, ...
Question about L7 LTd Pro Sports Trainer Treadmill
Treadmill powers on but belt won't move - Landice Sprint 8700 My Landice Sprint 8700 powers on and stays on. The elevation buttons work and the treadmill moves up and down. When I press the speed ...
Question about L8 80 LTD Executive Trainer Treadmill
how do i fix an landice l8 trainer l5 error only the error pops up and it wont move or start up that is a loss of speed error. you only get rid of it when the belt starts moving again
Question about 8700 Treadmill
Landice 8700 Programmable Treadmill with Baldor motor? It don't start. It tries to start but blinks on and off. It has a Baldor motor S/N W998 or W99B. Belt is fine and moves manually. As brushes have
Question about 8700 Treadmill
...Landice L7 treadmill and it will turn on and start moving all by itself without pressing start. Hello, it is either the control board or the overlay. I would think it is probably the start button on ...
Usually answered in minutes!
346 Questions
191 Questions
188 Questions
214 Questions
122 Questions