Questions & Answers for: jump the soleniod

...to be functioning properly. I can jump the soleniod and it will crank. I have replaced the soleniod but the tractor will not crank. Any solutions? Hi, has your problem been solve yet? please ...

soleniod clicks after letting it get a surface charge and then everything went black. Is there a thermal or fusible link I need to reset or replace? The jump connections were done correctly and it was

...jump start battery.release lever not working. use a jumper wire on fuse panel under drivers side dash panel, apply power and ground to trunk release soleniod through the fuse and open the trunk. look ...

...good. When I jump the starter soleniod and turn the key to the ON position, transmission in neutral, it starts very well and runs fine. you have an ignition voltage problem or ignition box

my cub cadet won't start just clicks ,i changed the fuse and tryed to jump start it no luck what do i do now? Check your soleniod.

...jump the starter. Pos cable on the starter then ground out the neg, it the starter turns over that isnt it. then check the smaller wire going to your soleniod, when you turn your key to the start ...

...jump across te battery terminal and starte on soleniod and it will turn over.If you have igniton switch on and jump the terminals on solenoid it will run. What could the problem be and what do Ineed ...

SOLENIOD BIKE WILL NOT START JUST CLICKINH NOISE FROM SOLNIOD If you can get to the solenoid,, take a screwdriver and jump the two large threaded terminals .... the engine should turn over. BE CAREFUL

...wires go on the soleniod for starter truck wont start with only if I jump it on the solenoid its a standard check the fuse box under the hood. refer to owner manual for start/alternator fuse ...

...soleniod is bad. Try jump starting the car for the heck of it. If it ends up being one of the other 2 things, make sure the person tests BOTH the starter, and soleniod. A starter is a LOT more money, ...