Question about NN-T655SF Microwave Oven
...down or give you a code. So Ultimately it could be MAg, Inverter, or Main PCB, not worth it. Get a new unit with full warranties and be done with it. You will save money in the long run.Good
Question about NN-T655SF Microwave Oven
...magnetron, control PCB or the inverter. It could have failed PCB, inverter module or magnetron. I recommend calling a service technician to diagnose and repair your microwave. NOTE: Do not attempt ...
...it mite be the magnetron or the inverter pcb or the turntable motor if it does not work when you fit the new fuse then a repair shop is best good luck and do unplug the unit before taken the cover ...
...inverter is properly connected to plug P2 on the display PCB & Adjust or Reconnect 7. If interlock switches operate correctly, replace 1100W inverter. 8. If problem persists, replace control ...
Question about GH9176XMS 1100 Watts Microwave Oven
...inverter pcb u need to unplug the unit and remove the outer screws when the lid is removed then on the right hand side of the unit as you look at it you will see a square box in the middle will have ...
...inverter is properly connected to plug P2 on the display PCB & Adjust or Reconnect 7. If interlock switches operate correctly, replace 1100W inverter. 8. If problem persists, replace the main ...
...inverter type then you need to check your magnetron and inverterboard also confirm if the relay on the main PCB is turning on when you press start button to cook. If it is a transformer type then ...
Question about MH2155XP Microwave Oven
...inverter and main pcb I have replaced the magnetron and inverter and main pcb still getting H98 error? If you wish to get some details about microwave repair; check the site linked here. ...
Question about MH2155XP Microwave Oven
the Switches and you have replaced the mag, the inverter is the power supply for the mag to work so either mag not getting power from inverter or inverter not getting signals from main PCB Timer board
Question about MH2155XP Microwave Oven
...inverter type microwave panasonic has to power no display the fuse and micro switches all ok, so what else should i check step by step? Check for faulty power supply circuit in the PCB assembly,check ...
Usually answered in minutes!
3,405 Questions
567 Questions
285 Questions
308 Questions
275 Questions
