Questions & Answers for: Chevrolet Monte Carlo intake plenum torque

...intake plenum. I just changed one on my fiance's 98 monte. The egr line runs through it and warps the plastic allowing the coolant to leak. A replacement part costs around $130, and comes with the ...

...intake, valve covers and plenum, as well as cleaned and resealed the injectors on my '96 Monte Carlo 3.1M V6. It started and ran fine for over an hour or more, but once I shut it down and tried to ...

Intake gasket and upper plentium ok the best way to find out this is call the chevy dealer! you will need a special to called torque to angle guage! the gm engines no longer have finale torque numbers

What are the torque spec's for the exhaust What are the torque spec's for the exhaust manifold on a 1996 Monte Carlo with a 3.1 engine. to torque nuts and bolts start in the center using a criss cross

16804/P0420/001056 - Catalyst System; Bank 1: Efficiency Below Threshold Possible Causes Leakage in Intake and/or Exhaust System Catalyst faulty Oxygen Sensor(s) faulty Oxygen Sensor(s) Control faulty

...intake gasket,be sure to torque the bolts to specs,and you will have no problem in the future. If you suspect that intake is bended, send it in a machine shop to chechk if it is flat, and if necesary ...

...intake gasket but now it over heats every morning .When i open hood the fluid is going out overflow so i crack the bleeder 2 or 3 times and then its fine till next morning then samething happens.Car ...

need vacum routing for map cencer map sensor is mounted directly in air plenum...just has o-ring

torque settings for bolts intake manifold The correct way is a real mess and hard to explain. As a mechanic I would tighten the vertical bolts first to 18 ft pounds and then the diagonal bolts.

2000 Chevy Monte Carlo 3.8. Water pump torque specs please. Question edited for maker. Question moved to category. 2001 Chevy Monte Carlo 3.8L Engine Torque Specs https://chevy-specs.com > cars > ...