mono block car amplifier and the way they have the amplifier hooked up is normal but one thing is the got two wires in the ground and remote turn on wie ........is that how im suppose to hook it up or
Question about Thunder5601 300W x 1 Car Amp Mono Subwoofer Amps Car Audio Amplifier
thunder 5604 ok so i jsut got this amp and system form my brother...and i have it hooked up the same as i had my old on hooked up and now i know it turns on but wont put out sound like i have the ...
...one told me if i install them that way my subwoofers would burn out. no you will not blow it out by hooking up both voice coils. But First before you do, what oms are they. and is your amp one oms ...
i have a mtx ta7801 amp that was working fine and just stopped i have changed fuses and hooked to direct power and still get no leds or sound take it to service center, you have internal problems
Question about Thunder 421D Car Audio Amplifier
...jaimemm_77, The MTX 421d is a mono amp. It only has one output channel. If you are asking about hooking up only one channel to the input, then no, the amp will not overheat. But the output will
...between 1-2 ohms total impedance in a mono conection , meaning whatever quantity of subs you have hooked to your amplifier,their total impedance should the minimum the amp handles that way all the ...
Question about Thunder5601 300W x 1 Car Amp Mono Subwoofer Amps Car Audio Amplifier
The amp turns on and the lights come on and all my wires are hooked up correctly but i still have no sound? Make sure your RCA's are hooked up, the take a DMM set it to AC volts, turn the deck up ...
...Mono amp its so its convenient for you to hook up 2 4ohm subs to it easily But both channels are actually connect internally together in parallel inside the amp unlike a 2 channel they are separate. ...
Question about Thunder 9500 T9515-44 Car Subwoofer
I have a Kenwood kad-9104d mono amp hooked up to a MTX T9515-44 sub with each coil wired to the amp in its own terminal although this amp only has one channel (500w rms x1 @ 4ohm, 900w rms x1 @ 2ohm).
Usually answered in minutes!
55 Questions
42 Questions
24 Questions
26 Questions