Questions & Answers for: Sharp hold button

...Hold down the MENU/HELP, ENTER and down arrow buttons and press the standby/on button. Keep holding down the 3 above butons until the LAMP 0000H appears on the screen. That will indicate that the ...

...reset...a tech with the button combo can get you into the eeprom reset (the controller of video control) The button combo is usually something like: {HOLD POWER BUTTON} {HOLD INPUT 2 SEC} etc

...hold the SET button, while holding the SET button press the TV button the red light should stay on - Then enter one of the following codes followed by the TV button again. then try the POWER. Repeat ...

hold the eject/open button, then turn unit on. Sometimes a combination of these odd procedures actually work. Sometimes holding the stop button, and hitting eject/open works too. Hope this is helpful.

...button ... Press and hold (in this order) button 1, 5, 6 and then button 9 for 5 seconds. Or, if you start from the power button end .. Press and hold (in this order) button 9, 5, 4 and then button 1 ...

...hold MODE button until you hear a beep, the unit will start 3 Press power button to shut off 4 Press power button to restart This worked for me. Gary check the manuals and go to error guide you will ...

...Hold down Enter button for 5 seconds it will unlock On my Sharp Notevision PG-B10S, it was the large green power button--press and hold 5 seconds to enable keylock, and again press and hold for 5 ...

...hold down the button that names that device). As you are holding the TV button, press and release the OK button. You know you have done this right when all the mode keys flash twice. Find the 4 digit ...

...simply a case of trial and success! (3) Nateinportland said : unplug, hold power button, plug in. If that doesn't work, unplug all the HDMI cables, unplug the power, hold power button, plug back

...hold the VOL- button on the TV's front panel. While holding the VOL- button, press and hold the INPUT button on the remote control. Hold both buttons down until the message "Service Menu" appears on ...