...it is probably a result of bad linkage to the governor (controls engine speed) and may mean the governor needs adjusting (easy) or the linkage to the governor is stretched or not connected
Question about Super Recycler Super Bagger Lawn Mower Rear Bagger 5
...linkage set-up to governor is questionable to the spring linkage arm on top of governor and throttle linkage in lower hole on governor arm. is this correct? Hopefully, this will clarify it.. ...
Question about Powermate Premium Plus 6250W Portable Generator
...clamp on governor shaft, then holding linkage in wide open throttle position rotate shaft as far as it will go in the opposite direction to that requred to close throttle to idle . Re-tighten
Question about Powermate Premium Plus 6250W Portable Generator
...governor linkage in direction that opens throttle valve, loosen screw on governor arm and turn rod in same direction until it stops, while holding in this position tighten screw on governor arm. This ...
Question about Powermate Premium Plus 6250W Portable Generator
...governor linkage at base of unit. With a needle nose pliers, turn small center shaft of governor linkage(the part that leads inside engine) in same direction you moved the linkage in earlier step. ...
Question about Powermate Premium Plus 6250W Portable Generator
...governor linkage is moving freely. It is the linkage that the throttle goes to on the engine and then a lever from that linkage goes back to the carb. The throttle cable works through the governor to ...
Question about Powermate Premium Plus 6250W Portable Generator
...governor linkage and or governor control fan arm " most small engines have them to control over speed" is binding or maybe has dirt and grass built up.. Or the return spring is disconnected. Once it ...
Question about Snowblower Snow Blower Starter Handle (Tecumseh)
governor linkage need to see cannot get it set Check out CHAPTER 4 GOVERNORS AND LINKAGE it shows the different governor systems used on Tecumseh engines. ...
Question about Snowblower Snow Blower Starter Handle (Tecumseh)
...you move throttle to run, engine runs at extreme rpm's and will not throttle down John the governor is probably sticking, check for dirt and debris, make sure spring/ linkages are still ...
Question about Snowblower Snow Blower Starter Handle (Tecumseh)
...governor linkage? I've been looking for picture of carberator throttle and the governor setting the throttle linkage and governor setting will be found in the workshop manual for the engine that you ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions