Question about EF 50mm f/1.8 II Lens
glue with a toothpick between the camera-side metal ring (inside the focusing ring) and the plastic lip of the lens body. I made sure to use a Q-Tip to wipe any excess off, and then what I did was put
Question about CP-220 Thermal Photo Printer
...glue between the shaft and the plastic part. Has not hardened yet, will keep you posted. George Had this same problem with my CP-200. This site was a great resource to finding the source of the ...
...to know what can be done to reattach it. Can I use superglue on the plastic tabs Thanks No, don't use superglue. Super glue will destroy plastic forever... Try other glue or double side scotch
...there somewhere in Benoni i can take the machine you have support of a roller feeder broken open the right door and see if the roller that you see is oin good position.try to glue the plastic
Question about PIXMA MP210 Photo All-In-One Printer
the plastic band the senses the .......... the plastic band that senses the position of the carriage has come off while i was putting the drive belt back on. How do i put the band back on? with glue..
Question about LaserClass 2060P Plain Paper Fax
...from it's pedestal. Good luck. By the way if the probelm keeps comeing back you might try super glueing a washer onto the teeter totter to provide a little more ...
...plastic, it will probably be not located properly these are known for dislodeging, Canon engineers simply glue them back in, switch off the power beofre doing this and when you switch back on it ...
Question about Selphy CP510 Thermal Photo Printer
...glue: To get iron axle free, in order to get broken plastic "pusher" off, I first unscrewed to bigger screws in the metal plate on left side and also the very litltle screw on front side (on/off ...
Question about DR-2580C Path-Through Scanner
...plastic towards the front protruding downward I belive on the right hand side towards the front of the top half but on the side of it. If its not there then it has broken off, if you can find it you ...
Question about DR-2580C Path-Through Scanner
...plastic lever which pushes down the print head. I hadn't noticed the crack. Glued with Bostik hard plastics clear glue. OP recorded the answer as follow; Now found the solution (the post didn't ...
Usually answered in minutes!
1,383 Questions
944 Questions
808 Questions
687 Questions
597 Questions