...cloth. Test the float to make sure there is no liquid inside of it and that it actually does float when suspended. Take care to reassemble the needle valve and float and bowl the way you removed
Question about Pressure Washer Projectpro Spray Nozzle
...float,needle and seat are stuck wide open.Once the carburetor bowl is full of fuel the float rises up on top which pushes the needle back into the seat shutting of the flow of fuel.As the engine ...
Question about Pressure Washer Projectpro Spray Nozzle
float is good and needle is ood gas does not shut off in bowl, float is good and needle is good is there a gasket where the needle inserts into the gas feed? have you checked the seat where the needle
...gas fills the block! The float needle is not closing all the way and fuel keeps leaking in to the carburetor. Replace the needle and make sure the float is not damaged and that the float pin is
Question about 2500 PSI Gas Pressure Washer
...float needle together. Briefly turn on the fuel selector and then back off. You are flushing debris from the float needle seat. It is a good idea to use carb cleaner to ensure that the float needle ...
...float and/or needle valve in the carburator. If the float is damaged or the needle valve or seat isn't able to close fully, gas will continue to flow into the float bowl then into the cylinder ...
Question about Stratton 020273 Elite Series Portable Gas Pressure Washer
...float or needle valve in the carburator float bowl. If the needle valve is stuck open, gas will flow from the float bowl into the cylinder and then the crankcase even if the motor is not ...
Question about DPD3300 Commercial Pressure Washer
...needle or float. Most of the time you can remove the float bowl and flush out any dirt. If there's a lot you should consider flushing the gas tank and check your gas can for dirt. If the washer has ...
Question about 2700 PSI 2.3 GPM Gas Pressure Washer 020486
...I would say the float is stuck down. need to pull the bowl off the carb and inspect for gummed up pieces. If nothing take the float out and inspect needle and seat make sure they are clear of
Question about 2700 PSI 2.3 GPM Gas Pressure Washer 020486
...after filling gas tank, gas drips from the carburetor. Needle and seat problem probably with the needle worn or seat worn or both OR needle sticking OR float and/or float level adjustment
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions