same problem. Broke 2 belts before I got online and noticed this site! What I found was, the roller ends were not turning freely. I had cleaned the hair (nasty) off the roller, but the ends were still
Question about Altima Upright Vacuum Model 2996AVS Vacuum
Just need to know how to change the belt on my vacuum cleaner It's an Eureka Altima 2996AVZ Step 1: Lower handle to floor to change belt Step 2: Remove the two screws from the top hood on the foot ...
Question about Altima Upright Vacuum Model 2996AVS Vacuum
The plastic ends on the brush roller have melted. Eureka Altima Model#2996AVZ Bearings in the end of the beater bar have gotten dry/ dirty and created enough heat to melt the ends. I'm afraid you need
Question about Altima Upright Vacuum Model 2996AVS Vacuum
How do you clean/take apart the roller brush ends. One end turns easily, but the belt end is somewhat harder to turn. one end is usually fixed the other is not :pull staight out on the end with the ...
Question about Altima Upright Vacuum Model 2996AVS Vacuum
...that you cannot make the roller turn with your hand on the uncentered end. I would compare the 2 ends and see if it is possible that the uncentered one has broken and become off center. If there ...
Question about 5849A Boss Bagless Upright Cyclonic Vacuum
The suction for carpet cleaning is great but there is very little suction through the hose. I have cleaned out the hose but there is still very little suction. What else can I do? Have you tried ...
Question about 2991AVZ Bagless Upright Cyclonic Vacuum
...the cradles that hold the end caps. The square end caps can also be pulled off the bearings at the ends of the rollers. I had a lot of stuff wrapped around mine creating a lot of drag, but the ...
My brush roller is loose and making a loud noise and keeps reseting. I Have the same problem. It is the end of the brush roller opposite the belt end. It binds up and gets hot, then melts the plastic ...
I have Eureka model 2961. The bearings on the end of the roller have seized and melted the plastic end. I was wondering if you know where I can find replacement bearings and a new plastic end cap. ...
Question about 3041BZ Upright Vacuum
the brushroll, or the bearing in the cap got so hot that it melted the plastic end. Either way, the ends are not replaceable alone on these, a new brushroll must be purchased and installed, preferably
Usually answered in minutes!
157 Questions
154 Questions
86 Questions
80 Questions
71 Questions