Questions & Answers for: dremel shaft lock loose

Dremel shaft lock spinning I have a Dremel 300 and the shaft lock assembly isn't working to hold the shaft so I can get the collet nut loose. When I try to get the collet nut loose while holding the ...

lock down on the bit. The shaft of the bit just falls out no matter how much I tighten the collet nut. I bought a new collet nut set, but that didn't help. None of the bits I have lock into the device

...Dremel lock nut won't budge. My collet is stuck! How can I loosen the bit? You'll need to use either the built in shaft lock to hold the collet in a fixed position, or use a pair of slip joint pliers ...

...Dremel or multi-tool. As I have never seen any nail tech take the machine directly to someones nails. I will assume there is and extension. You'll need two tools, a pin like a nail (woodworking nail ...

...Dremel 300 and the shaft lock assembly isn't working to hold the shaft so I can get the collet nut loose. When I try to get the collet nut loose while holding the button of the shaft lock the shaft ...

...dremel tool works well to cut slots in the security bolts. Then a short straight blade screwdriver bit turned with a small ratcheting box end wrench is the easiest way to unscrew the security bolts. ...

shaft loose or pull it off completely with the nut and then seperate the nut from the shank when it is out of the Dremel Tool. A lot of machine tools are tightened too much, which makes the shanks get

...shaft. I have the correct code and the override key, but the problem seems to be with the actual knob mechanism. The keypad unlocks it but the knob just spins. Short of cutting my way in, any ideas? ...

t spin accidently hit lock button with the dremel on. motor runs, shaft won't turn. My motor was turning but the flex shaft wouldn't. I took the flex shaft loose and spun it inside. Works fine now