carburetor fuel flow Rebuilt carbs. Replaced all o-rings and gaskets. When testing with a fuel "iv" bottle (No gas tank), the fuel gushed through and poured out of the airbox side on all carbs. I ...
...Drain the carburetors. There should be a screw on the lower side of each carb float bowl. Remove the screw then replace it after the fuel drains. Any water in the gas? Remove the water trap bowl at ...
kawasaki zx10 1989 has been standing for 10 years. have had carbs cleaned twice and reset set all carb settings. but still wont run right could you help There could be other things involved. Have you ...
idle adjustment screw came out. and i don't know much about motorcycles. i was wondering if anyone could post up some pictures on where it goes. thank you I dont know how to get pics for you but I ...
1987 kawasaki ninja zx10 wont stay running when warmed up it 1987 kawasaki wont stay running when warmed up it sputters and backfires i tried different coils,pick up coils,cdi,gas tank,new plugs still
...the old fuel from the carbs, undo the drain screw in each float bowl untill all the fuel is removed retighten and try to start again, may need carb overall, poss choke jets in carbs blockage ...
I have an 89 ZX10 it sat for about 8 months when i fired it up it ran like a pig coughing & spluttering backfiring. I cleaned the carbies put in new plugs checked compressions 170 - 180 on all ...
Oil level. Checked with engine on or off? How many quarts approx to fill it? Gas petcocks 3 settings. one is on. One is reserve. One is prim? What is prim? What is the spark plug size? 18mm? Special ...
I have a Kawasaki 1988 ZX10 and there is a flat spot at about 3000 RPM. The problem seems worse when the engine is fully warm. Also I don't know if this is related but when you leave the bike for ...
Usually answered in minutes!
27 Questions
8 Questions
