Question about Consumer Products 4.0 Amp, 13 In. Trimmer
...right when I put it back together... Any help please... with the cover in your hand pull the cord out with a pair of needle nose pliers or a little screw driver and where the cord go through ...
...revealed a freely turning flywheel, then check the starter mechanism looking for a bound starter cord or other obstruction. If the spool can't be turned CCW, then suspect that the spring is ...
Question about Mighty Lite Lawn Trimmer
unable to base the cord on my homelite 26ss weedeater when i place cord on the base it fits but as soon as i pull on the cord it comes out of place. i've tried over and over as i place cord in its ...
i had to fix the pull cord and know the cord will not return to the housing i cant figure out how to fix you need to untie the pull cord from the handle... and wind up the srping the wile holing it ...
...it is probably better to pay somebody else to do it. That said, remove the starter cover with the cord and pulley inside. If there is a plate holding down the cord pulley, remove it and carefully ...
...it is probably better to pay somebody else to do it. That said, remove the starter cover with the cord and pulley inside. If there is a plate holding down the cord pulley, remove it and carefully ...
...STRING WON'T RETRACT BACK INTO CRANK CASE This is an instruction for replacing the starter cord, but your problem involves the same steps to repair. This is a messy frustrating job, and if ...
pull cord on homelite ut20006 trimmer need to reattach pull cord to engine on the side where the pull cord was remove casing pull the cord through the hole on the casing wind the spring back on ...
broken pull cord s/n mc2700545 How to replace a broken pull cord on a leaf blower.1) Remove Hex bolts holding plastic leaf blower housing in place with your hex wrench. you may want to cut the cord ...
Question about Consumer Products Backpack Blower/Vac, Carb
pull cord wont recoil homelite xl 12 pull cord does noy have enough tension to rewind all the way You will need to take the cover off to get to the recoil, then remove the pull handle do not let go of
Usually answered in minutes!
778 Questions
175 Questions
129 Questions
92 Questions
66 Questions