Questions & Answers for: GMC a c clutch replacement

clutch replacement Is it possible to replace a/c on this pick-up without having to remove a/c compressor? Looks possible...not sure though. Compressor is working great, hate to remove it if not needed

Just replaced thermostat and now my fan clutch runs continuously I just replaced my thermostat on my GMC Envoy with a 4.2 liter engine and now the fan clutch does not disengage. Could I have somehow ...

...or throw out bearing replacement or clutch replacement if no adjustment is left. consider the age and mileage if clutch has never been changed, would recomend it rather than throwing parts at

...air is ice cold too i checked my relay and its fine, has the proper voltage as per my book, but the clutch just kicks off for a few minutes then back on. when it stays on the air is very cold as it ...

is it fairly easy to install a clutch master cylinder (1994 gmc sierra 2500)my main concern is disconnecting and reconnecting the push rod to the clutch pedal through the little hole in the fire wall ...

the clutch pedal dropped to the floor....was no smell of burnibg clutch, just lost pressure..no fluid leaking and resevior is full. replaced slave cylinder and line 3 years ago and rebuilt master ...

...do i need a new thermostat or could it be something else? could be thermostat but also could be clutch fan,or a bad head gasket. REPLACE THERMOSTAT.CHECK CLUTCH FAN WHEN ENGINE HOT CLUTCH FAN ...

how to remove the a/c clutch from a 1998 gmc sierra 1500 5.7 l I believe this AC compressor is the same as my '95 Astro. The clutch is pressed on to the compressor shaft. You should see a threaded

...Clutch Replacement - Chevrolet K-1500 ' GMC ' Chevy ... ? 15:38 www.youtube.com/watch?v=4y-32SqULUs Jan 17, 2012 - Uploaded by ClassicManuals.net Clutch Replacement -- Chevrolet Chevy C/K 1500 Clutch ...

My clutch will not engage. I had to replace the clutch, and now it will not engage. I replaced slave cylinder and still nothing. HELP First make sure that the problem is the clutch not engaging ...