Questions & Answers for: Hyundai how to change a clutch

...change gears. When releasing clutch pedal, clutch engages within 1-2 inches from floor. I don't see any leaks at clutch master cylinder or slave cylinder and the slave cylinder moves when pushing the ...

revs slow to drop when changing gears i have to wait for revs to drop to let clutch when changing gears and it is not sticking cable What the answer to get some free play on clutch pedal ? right the ...

well clutch was slipping so changed it no joy changed slave cylindar and still slipping changing the master now as thats all of it changed. if that doesnt work any ideas to how to stop clutch slipping

clutch peddle, unable to change down from high ratio gears to low ratio gears, having to knock into nuetral pump the clutch to select gears already had master cylinder changed This sounds like you may

Whinning noise from engine when changing gear went to pull off in 1st gear car stalled and now cannot engae gears is this just the clutch cable or something else Hi, I think the noise you were getting

...releasing the clutch in 1st gear it makes sound like (kat kat kat ) and then the car moves later i changed the clutch plate pressure plate and release bearing..again i m facing this kind of ...

...replace the clutch package. I would replace the master and slave at the same time. Have the oil changed in the transmission and will be good to go for another 100,000+

...and its hard work to change ..my engineer too 6 hours to change it .also change the gasket at the clutch end .they cost around £20 .and change your oil in your gear box and the transfer case ...

...you accidentally release your clutch when changing gears and it hasn't engaged properly. I also changed my manual gear box oil. THANK YOU Does the car want to pull when sitting still in gear with ...

change AC clutch on a 2001 Hyundai Santa Fe 6 cylinder To change an air conditioning compressor clutch, you remove the bolt in the center of the clutch, remove the pressure plate, then remove the snap