CAP AND ROTOR WHAT DOES A BAD CAP AND ROTOR LOOK LIKE on the cap the contact points inside will look coroded--not square edges and burnt spots where the rotor fires against,the rotor will look burnt ...
engine will crank but no firing the engine will crank but nothing fires. we had checked the fuel pump, filters all fine, suspect its a pick up inside the distrubutor cap? any solutions? check the ...
I need the possition of #1 on the distributor cap I need the position of #1 on the distributor cap for a 4 cylinder chevy s-10 Remove cap. Remove number one spark plug. Turn key off...have friend ...
Condensation in the Cap on the rotor and in the distributor, 2001 Chev Blazer Xtreme 4.3 v6. I had misfires,and then it stopped running.pulled the cap,and rotor off and found extreme corrosion,burnt ...
...on the oposite side? First off, the firing order on six-cylinders are 1-5-3-6-2-4. The Distributor Caps of today sometimes have the configuration as to when a certain cylinder fires within the top
...Once there, remove from vice, pull the now pressed out second cap out of the yolk hole. Now both caps are off, and you can just pull U-joint out of yolk. Putting the new one back in is tricky too, ...
...off the end of the 2x4.... #2. you will need to pull the c-clips/retaining clips off the u-joint caps(some are on top of cap and some on bottom).... #3. next you will need an old socket that will ...
service engine soon light comes on Have you checked the gas cap to see if it is on tight? If you purchased gas in the last couple days it might be the solution. Tighten the cap and drive a couple days
did a tune up on a 2002 chevy blazer. plugs wires cap & rotor. i didnt realize the new hold down bolts for the cap were taped to the insideso when i started itthe rotor and cap got damaged so i ...
Usually answered in minutes!
2,307 Questions
1,793 Questions
1,647 Questions
1,619 Questions
1,503 Questions
