Question about 42 in. Precision Cut Plus 24hp Lawn Tractor
to replace. Get the model number off your tractor before you go to buy the part. sounds like a warped mower deck strait edge blades if all is true measure blade height to level floor correct as needed
Question about 21 Hp 42" Deck, Ys 4500 Lawn Tractor
BLADES CUTS LEVEL, LEFT SIDE DIGS INTO THE GROUND RIGHT the right side cuts level but left side doesn't well the answer i have would be that someone stepped on the deck which will cause the adjustment
How can I adjust the blades deck is adjusted by 2 leveling bolts on each side at edge of frame....also hold deck up...should be 1/2...use a wrench....i take two sockets and line up with blade ends and
Question about 42 in. Deck 19.5hp Lawn Tractor
lawn in two uneven strips half side is ok; the other is too low First, check the blade, it may be bent. If not, there is an adjustment nut (9/16) on each side in the middle of the deck hanger bracket.
Question about 42 in. Deck 19.5hp Lawn Tractor
...blades are not level, how do I fix? check the front tire air pressures then for a bent blade Its not the tires it is the blades don't line up.One blade is three-quarters of an inch lower.Is there a ...
...level deck. Changed blades, Leveled deck on level concrete surface. Checked air pressure on all tires. Appears to be too much pressure on front center wheel on deck (constantly cocked over). Front ...
Question about Lawn Tractor 48" Deck, 23 Hp, Model# Yth2348
...blades drag on the left side cutting into the dirt. check blade to see if it is bent or perhaps the blade spindle is bent are the tires properly inflated on a flat surface ceck to see if the deck is ...
...blades, blades not installed right and an un-level deck cause that. Hope this helps. If the deck has not been altered and the blades are not altered or bent,maybe you have a soft rear wheel.
Question about 20 hp 42 in. Deck Lawn Tractor - CA Model
...blades. Level left to right then level front to back with owners manual instructions. Before trying to level a mower deck that was previously cutting even and now is cutting uneven you may want to ...
Question about 20 Hp 42" Deck Lawn Tractor
...blades common problem with uneven cut is a bent blade. Next find a level spot like a padio and take a torpedo level place it on the front center side to side not front to rear. On one side or the ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions