...ic. If it happened from a speaker going bad you must replace the bad speaker. If it was a random part failure there is not much you can do, you had some bad luck, thats all. If you do not know how to ...
...IC being bad. If you have a bad speaker it could shut down the amp IC, but normally it will make the amp IC go bad if a speaker gets shorted. Try disconnecting one speaker at a time and see if the ...
...IC inside the radio is bad. More often than not, it is the amp IC. first double check that you have all speakers connected right and that you don't have a speaker wire that may have an exposed area ...
my kenwood flash protect after i reset it sounds like it could be either a bad speaker, a shorted speaker wire, or a bad output ic inside the deck. kenwood kdc-w4034y flahs "protect"
...and then shuts off turns on only momentarily and then shuts off leaving the red standby light fast-flashing your receiver has a bad audio output ic.replacing ic will take care of the ...
...checked wiring harness connection, speaker connection, fuse looks good. This unit is installed in our hot tub.... bad deck? bad wiring? any ideas? Thanks, Jamie maybe the amplifier IC are ...
my kenwwod radio model dnx 5120 shows protect on the screen when it comes on. what does that mean it means you have either a bad speaker, shorted speaker wires or a bad output ic.
...is n protect mode . try checking your speaker wires for shorts and bare spots. also check to make sure you have no shorted or bad speakers. if they all check out good, you may have a bad output
screen flashing protect you probably have a bad speaker. a short in your speaker wires, or a bad output ic inside of the deck.
...it still saying PROTECT. I even test another receiver and that one is working fine! What can I do? If the wires and speakers all check out fine, you probably have a bad output ic or volume control
Usually answered in minutes!
202 Questions
203 Questions
165 Questions
142 Questions
149 Questions