...jack to raise it (being VARY careful not to contact the blades) and lower it onto 4 blocks at least 4 inches high. Place the blocks at the 4 "corners" of the deck. Two blocks long enough to run past ...
Question about 12 - 905 Contractor Grade No.5 Smooth Bottom Jack Plane
I need an assembly diagram for a Stanley #5. Which way does the blade face up, and where does the chip breaker go? I recently bought a #5, used, and I am not sure that it was assembled correctly. I ...
Question about 2001 Stratus
...plane. Wheel bearings are likly and I've changed many to solve this problem but it's esy to pick the wrong one with e vehical jacked and on jack stands suporting the car by the lower control arms ( ...
...jack as a back-up, remove the lug nuts and remove the tire from the vehicle. Sometimes this is hard to do, as alloy wheels often "stick" to the cast-iron suspension parts after many miles of not ...
No power of my SC-HC3 I have good and bad news for you. If you have a UK power plug for 250VAC (odd shaped three-pronger), then you should be able replace the small 5 Amp fuse inside the plug ...
Question about SCHC3 Micro HiFi System Speaker System
...jack stands, tires front chocked, both sides. ! car cant roll. 2: release the hand brake, 3: see drum some have locks on the drum there , in plane site if yes, remove those, now. on the stud or the ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions