Questions & Answers for: GMC 2 8 tps replace

Question about 2003 Sierra

2 Answers

...tps alone. You do not have to change the entire throttle body. It shouldn't be riveted in place, it should have screws or bolts on one side or the other. If it's riveted in place, use a dremmel and ...

Ad

...replace TPS. Good luck Auto Zone or Parts Source has this part and can be replaced with in 20 min. Both parts store will have the step by step instructions and i believe the cost is around $65.00 for ...

Ad

replace your TPS. The TPS is located on the throttle body-follow the accelrator cable where it meets up with the TB its right there, you'll see two lead wires connected to it. The TPS sends signals to

Question about 2003 Envoy

1 Answer

...has a 2003 gmc envoy......issues of stalling and no power were addressed by test at autozone....tps code 220 came up so tps was replaced...truck runs a little better but still had a lack of ...

...KEEPS APPEARING, REPLACED T.P.S, unplug it and it does not cange idle speed or anything Hello: The TPS has no effect on idle speed, make sure the throttle plates in the throttle body are clean.

...it goes into gear will not idle at all Trouble Code 22 indicates that the Throttle Position Sensor (TPS) is reading abnormally low. TPS volts should be close to 0.42 V at closed throttle and rise ...

Have a 1995 Jimmy 4.3W MPFI with OBD2. Error is P0122 TPS sensor and have replaced that. Idles between 700 and 1200. Have replaced injector spider,fuel presure reg,EGR,new gasket, fuel pressure is ...

i have a 97 gmc sonoma 2.2 engine.i got a tps code and replaced it and map sensor to find that i have only 1.7 volts going to map sensor and tps,coolant sensor is getting 4.9 volts and ignition ...

Question about 1995 Jimmy

1 Answer

...tps, turn it a little to adjust RPM's, retighten nuts or bolts, once you feel its right. the rpm's that is. tight is tight, too tight is broke ! the EGRvalve is something to consider with these ...

Question about 1995 Jimmy

1 Answer

Trouble Code p0122 tps has been replaced and still is not fixed. It dies when accelerator is pressed, jumps and misses, let of on the acc. and it catches up and accelerates sluggishly. Can the be ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2004 GMC Envoy
2004 GMC Envoy

2,225 Questions

2000 GMC Jimmy
2000 GMC Jimmy

1,363 Questions

2003 GMC Envoy
2003 GMC Envoy

1,368 Questions

2002 GMC Envoy
2002 GMC Envoy

1,418 Questions

1997 GMC Jimmy
1997 GMC Jimmy

1,123 Questions

Top GMC Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...