Question about MOMO Force Wheel And Pedals Set
...you one for a charge. Look for a 24 volt DC transformer which will provide >=0.75 ampere. It must also be a 'center pin positive' type. It could use just about any 1/4" jack to go into the
Question about DRIVING FORCE FEEDBACK STEERING WHEEL W/PEDALS USB FOR PS2 (VGITECHWHEELPEDALSUSBPS2)
24 volt dc, .75 amp. P=iV (power = current x Voltage. as the voltage is high compared to the 5 Volt USB connection, you can get allot of power from the 24 volts seperate power supply as opposed to the
Question about DRIVING FORCE FEEDBACK STEERING WHEEL W/PEDALS USB FOR PS2 (VGITECHWHEELPEDALSUSBPS2)
...power supply is 24 volts and .75 amps. Center positive outside sleeve negative. Hope this helps. hi i need help im looking to buy a cheaper steering wheel i fell in love with the logitech g25 but its ...
Question about DRIVING FORCE FEEDBACK STEERING WHEEL W/PEDALS USB FOR PS2 (VGITECHWHEELPEDALSUSBPS2)
...power back on and go to the thermostat while the wheel is spinning and turn the fan to "on" and run the temperature low. If the fan continues running up to speed, it needs a new capacitor ...
...24 volt system). Test the voltage at the charging port by placing the two probes into the two outside ports (there's three ports in a triangle...test the two opposite ports.) You should get a reading ...
Question about MOMO Force Wheel And Pedals Set
...on parts before shipping box was discarded. Need power supply and threaded post for tightening center clamp. Power supply is 1/4" 24 volt dc (center pin positive) at 0.75 A. GL on the allthread
Question about Associated Equipment 6002B 6/12/18/24 Volt Heavy-Duty Battery Charger
518 cat skidder gearmatic winch keeps turning when put in free wheel 1985 pull the secondary clutch apart on the winch and clean with emory cloth or sand paper and u should see a change in this ...
Question about MOMO Force Wheel And Pedals Set
Need power supply for the red logitech momo force feedback steering wheel. Can U help? 1/4" 24 Volt dc (center pin is positive) at 0.75 A or more. The device will only use what amperage it requires.
Question about MOMO Force Wheel And Pedals Set
volt output. Isn't the charger should output 24 volts when it is not connected to any battery? If the battery has stood for two years with out a charge it will no longer be able to hold a charge renew
Question about MOMO Force Wheel And Pedals Set
...24-Volt Battery-Powered Ride-On stop after riding about a minute or so. It will start back after a minute or 2 Hi, Drexell you may have a faulty battery connection for this situation I would call my ...
Usually answered in minutes!
27,926 Questions
21,069 Questions
11,924 Questions
9,005 Questions
5,602 Questions