Why frequently relight my pilot?

SoundS like the thermocouple needs replacing .Pilot not holding .

How To Relight Your Pilot Light On Your Water Heater ...

? 7:54
https://www.youtube.com/watch?v=gqM7kMkkFAI
Apr 15, 2013 - Uploaded by TipsNNTricks
How To Relight Your Pilot Light On Your Water Heater. TipsNNTricks .... I answer the following questions in this video. How can I relight my pilot ...

First make sure you have gas, then open lower section of this dryer you shoul see screws you will see a place to relight the pilot , if you smell gas before doing anything then stop your repair, see if the pilot is lit then push the red button and hold it relight pilot hold this button for a few min's after it relights, if it dosent relight check power goign to gas valve near pilot . Gas units have very little problems you may have just lost gas pressure and need to relight it , let me no ! what you see and we wuill go from there

Hi,
To relight it you need to pick up the top from the front and then relight the pilot that is in the center between the burners with a match or a lighter...

heatman101

You need to hold down the pilot button all the way down (turn selector to pilot).

When pressing the pizo count to 5 then press and repeat. It you just click it constantly you will lose your mind.

The pilot is located in the bottom of the stove, you will have to remove the bottom drawer, and you will see the pilot in the back, you can relight it there, if there is no bottom drawer you will have to remove the bottom cover inside the oven and this is the location where you can relight the pilot.

The valve should be able to be depressed at the pilot setting and as you slowly depress it you should get it to move past pilot to off. You do not however need to go to off. You can go back to pilot and relight it and go back to on.

If it will not relight and will not go back to off it sounds like the valve is damaged internally and will need to be replaced.

My pilot light also just went out on my water wizard 13P when you relight ensure all buttons are equal in height or none depressed then hold far left button down whilst striking ignition button till pilot light ignites keep left hand button depressed for a further 3 seconds after pilot light has ignited I hope you have hot water then

your unit dioes not have a pillot that would need need relighting, it instead uses a glow bar ignitor. auto pilot.

How do you relight the pilot light on a rudd heating and air conditioner