HOW TO REPROGRAM M7310 WITH NEW EXTENTIONS

Check your button programming using Feature *0 to see if the lines are programmed to your phone.

Most likely you can swap the phones. On older systems it might not work so I would try one first. You do gain extra buttons which can be programmed as desired. Any buttons you had on your M7310 would be on the T7316e. You can check the buttons by pressing Feature *0 this will allow you to check any button on the phone.

you may need to reprogram some buttons. Read this: https://downloads.avaya.com/css/P8/documents/100142786
This is the telephone user card. Take note 'button inquiry' 'Button programming' and button labeling (desktop assistant (downloadable button labeler)(change font for size and bold the lettering)). If you need the feature codes for your Norstar sets... google 'Norstar feature codes"

feature 983
it will say log- press 1020000
it will say password-under that it says reset-push that soft key!! press release.
default will be 0000 once you access voicemail(981)

Hi there, in regards to voicemail, many service providers have different ways of setting up voicemail ... most of them have different input types of codes which you can enter with your phone keypads. This will either activate or disactivate the voice mail. The best thing is to ring them up and ask them for this code. I can help you further but then I will need all your details of your phone provider and I think this will be a longer process than calling them. I hope this helps and if you have any questions please do not hesitate to contact me. Good luck with that. Hope this helps.

pdf.textfiles.com/manuals/.../Samsung%20Prostar%20DCS%20Compact%20System%20Admin%..

pdf.textfiles.com/manuals/TELECOM-S-Z/

panasonicmadeeasy.com/SamsungManualsLead.htm
Above is your setup manuals.

Unfortunately it is NOT just a simple job of moving the instrument, one has to reprogram the system to "Tailor" it to everything.

You need to use the manual and reprogram the system to it's new configuration.

Feature #85 (Note #FEATURE CODE deactivates that feature code)

If the extension was a swap of the old M7310 with a new(ish) M7310 no additional programming should be necessary. However if the phone was replaced with another type of nortel set(M7208, M7324,T7313 etc.) then the phone will default to its base features. To re-program the feature keys press feature *3, the button you wish to program, and the feature code for that button

Sounds like the main phone(221?) has an answer dn key on it.
To delete the answer dn key you need to enter programming by pressing the feature key followed by **266344.When prompted to enter the password enter 266344.
The screen should say TERMINALS&SETS. The 4 top line/feature keys are now used for programming.
At the terminals&sets prompt, press the show key (top right arrow). The display should now ask for an extension number. Enter extension number you wantdelete the answer dn key from.i.e. if entension 223 is also ringing on 221 enter 221.
Press the show key (top right arrow)
The display should sat LINE ACCESS
Press the show key (top right arrow) .
The display should say LINE ASSIGNMENT.
Press the next key (bottom right arrow) 4 times .
The display say ANSWER DNs.
press the show key (top right arrow)..
The display should ask for an answer dn number.
Press the SCAN key (one of the three soft keys near the display)
The extension that was ringing on this set should be listed here.
Press CHANGE til it says UNASSIGNED.
Press the release key when finished

These manuals are available on the norstar web site.