I have a amica AWCT 10L washing machine and it starts to stop in the middle of spinning giving a red light on the strat/pause button.

Hi from retired Englishman in SW France,

I would gently suggest as a first step that you clean the drain motor lint tray/filter. So many 'faults' are caused by blocked filters and many machines will not even go to spin or release the door lock if there is any water still left inside.
Here are my complete guidance notes for checking both the drain motor filter and the drain motor ;-0)
-------------------------------------

If you are unsure where the filter is, it is often behind the front lower (kick) panel (or in some machines at the rear in an awkward position!) and most are held in by a round cover/knob. Sometimes the filter will not come out with the cover and you will have to persuade it to come out to play!

REMOVE POWER AND ENSURE YOU HAVE A WATER RECEPTACLE/RAGS TO SOAK UP THE WATER WHICH IS BOUND TO POUR OUT!
It's surprising what people have found in theirs! It is always worthwhile checking it on a regular basis.
Now- whilst the filter is removed it is normally possible to see the drain motor and ensure it is not jammed by a foreign object such as a needle or a toothpick. It should be able to be turned by hand/finger- the power IS OFF!
At this point it is also possible to test if the motor works. No clothes or water in the machine, select a spin cycle and put the power back on. You should be able to see the motor turning at some point, possibly straight away. Using something suitable like a glove see if it is easy to briefly slow the motor down. If it is easy then the motor is malfunctioning!

If these actions have not cured the problem, it could be the control board OR the main motor. Motors will show weaknesses when commanded to spin.

If this has assisted you please consider a 4 thumbs up for the rating.
Thanks and good luck!
John C

Check for water leaks, I've had 2 of these both with motor faults caused by leaks one showed that light fault.
Unplug the machine.
Remove the front panel that holds the drain plug, there is a screw on both sides of the machine take them out and pull the panel off.
If there is water, water stains on the bottom of the machine or rusty bolts you probably have a leak.
Stop using the machine until it's fixed or the water will damage the motor.