Jabra BT2080 - been working well, charges and shows green charged light but bluetooth doesn't light up and unit shuts off.

http://www.youtube.com/watch?v=Sm8cSkyTmfA
try this...

ok ok

Here is the link to dell solutions site on connecting a blue tooth device.....http://support.dell.com/support/topics/global.aspx/support/kcs/document?c=us&cs=04&l=en&s=bsd&docid=DSN_341240&isLegacy=true I hope this works

I also have laptop hp 620 and the jabra bt2080 which are working through a driverless bluetooth usb dongle v2.0 (China) after installing jabra pc suite_2.5.6. It is under my experiment as at the moment only the mic is working when you start windows speech recognition program. i am trying to get it working as playback device to listen music instead of headphone through jack.

Most Bluetooth headsets require a passcode to sync with the phone and to make sure that is the device you want to sync with. Each of these manufactueres usually have a default passcode to use. It is usually in the manual.
For your Jabra BT2080 Bluetooth model the default code is: 0000 (4-zeroes)
Here is the link to your manual: http://www.jabra.com/sites/Jabra/GNimages/Products/WirelessHeadset/BT2070/BT2080_UM_6909.pdf

Hello,here is the code to pair the jabra BT2080 bluetooth headset with the phone,when it ask for the pin code,kindly type 0000 and you are good to go.

take care.

Charge it Properly and Press it for 4-6 Seconds . Or replace your battery
Rate my answer and Support me

This bt2080 is not work with ps3 because your ps3 bt is ftp profile and it ask for pass key and we can't enter passkey in bt2080

Not sure if this is a solution or if it occurred by chance. Like many on here, I put my Jabra JX10 away for a few months while not using it. The time come for me to need it once again and found that it was dead. Made an attempt to charge the unit with negative results. The unit would only show a green "charged" LED indicator as if the unit was fully charged. I tried plugging the unit into the charger multiple times, and took the cradle out of the loop and just used the AC cord alone. Still with the same results. I pulled the outside cover off (slowly), to be sure not to break the small fragile tabs that hold it in place. The battery takes up majority of the space. Removed the battery but DID NOT disconnect from unit. Plugged the charge cord into the unit and immediately got a red LED charging indicator. While charging, placed the battery back inside and put the outside cover back on. The unit continued to charge for a little over an hour before the green LED "charged" indicator came on. I used the unit throughout the day to test it with no problems. Not sure what removing the battery from unit did, especially when it was not disconnected, but it worked. I hope to see similar results.

change the battery