On the spin cycle, it makes a banging noice, rythmic, about 2 per second....only on the spin cycle... can you help???

Ive checked thru the top and back cant notice anythin brohen but when i do spin tbe tub the banging noice is coming from in tbe drum and its pretty wobbley

That is your motor switch banging back and forth between the start and run winding. load to transmission or bad motor.

Could be off of suspension unit or Springs not right...Drum bearing also could be gone...Lots of play within inner drum

Just random input, I apologize if this is of no help to you. I've only experienced this with my washer when clothes somehow get bunched up on one side of it.  The best I can tell you at the moment is to make sure there is relatively equal distribution of clothes around the "washer bucket thingy" if you hear the bang bang bang again.

• Hi,
• Try these:

1. Balance the load
   
2. Level the machine
   
3. Inspect the water pump for a blockage
   
4. Inspect the coupling
   
5. Inspect the transmission
   
6. Adjust the drive belt tension
   
7. Check the motor bearings
   
8. Check the drum brakes
   

please rate my suggestion...

if the basket has excess movement separate from the agitator or tub then the hub nut may be loose or maybe the tub rusted out and broke. you will need to pop the top of the agitator off and remove bolt holding it to shaft, pull agitator out and look at hub nut.

With the lid open, set the cycle to spin and press the lid switch button with a pen. Wait until the drum gets to full speed and release the lid switch. If the drum makes a knocking/ thumping noise and doesn't stop spinning within 2-3 seconds, the basket drive block is worn and needs to be replaced. (The basket drive block is located on the gearcase drive shaft, under the tub and agitator) If this has been happening for a long time you may need to replace the brake and drive tube assembly as well.

Basket drive block part number is 389140

If that's not it, let me know and I will try to help you further.
Good luck!

if new did you remove shipping strap in back..the unit cant lean more than 2 degrees..make sure clothes are even in tub..try to wash clothes alike..

1 press power ( to wake up washer)
2 press Home ( it may already show HOME)
3 press HELP
4 press and hold MY CYCLES and BACK (for 3 to 5 seconds)

the service mode diagnostics screen will come up
it will show what errors are recorded..( if more button is displayed then also go to next list)

be sure to write them down exit will clear the codes and run a test

let me know what it tell you I can help...

more then likely that the pump has some kind of blockage in it this will cause the washer not to empty fully which when it goes onto spin it will bang about due to the water going from side to side check the pump will be underneath just were the drain hose goes into the washer you will have to strip to get the blockage out once done it should work fine m8