Roper washer water keeps filling and running right out. Never fills up. The washer is just over one year old.

Drain hose too low to ground. Must be 30 inches or more above floor.

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Tub keeps filling does not overflow.
Solution:
Drain hose must be 36 inchs above floor level to prevent siphoning.


If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

It's in the drain hose somewhere,during the fill the water gets as deep in the drain hose as it does in the washer,during the wash the pump runs in reverse keeping the water level in the hose low,during the drain the hose is filled again.
Prop the washer up in front on a couple bricks or boards,start putting in water until it starts to leak and take a peak under the machine.

posibble bad timer. if it is skipping over the agitate.

SOUNDS LIKE YOUR INLET WATER VALVE HAS CHUCKED IN THE TOWEL.
WHEN YOU TURN THE MACHINE ON TO FILL UP THE VALVE OPENS TO LET THE WATER INTO THE MACHINE, IF THE VALVE DOES NOT OPEN THEN NO WATER WILL ENTER IT
THE VALVE WILL BE BEHIND THE PANEL WHERE THE HOSE ENTERS THE MACHINE
THEY ARE REASONABLY CHEAP AND SHOULD BE ABLE TO BE REPLACED BY A HANDYMAN OR WOMAN, JUST MAKE SURE YOU PUT THE WIRES BACK ON THE SAME TERMINALS AS THE OLD VALVE

The problem is most likely the water fill sensor switch. If it is telling the machine that it is full, it will go right to agitate.

Sounds like a lid switch. If it fills and just sits there, Im working on a tutorial for this. Dave www.washermd.com

If you hear the motor running when it is draining then you have a bad timer. If it just drains out and the motor is not running then you have a siphon problem which is caused if the drain hose is too low. Let me know what you find.

ck lid switch probably broke if switch lever is still in up position try pushing it to bottom of travel with pencil..

check the water inlet valve