I have a Pride go-go ultra which is working fine, with new batteries except that on occasions when I insert the key I get a Bleeping signal and the scooter will not start, after repeatedly removing key it eventually starts and is ok for days. It is kept fully charged.

Test the battery charger output voltage.

Most likely the joy stick and the circuit it controls is defective.

Hi If U left the KEY IN.... When installing the batteries this can cause the controller to shut down remove key for a short time then try to turn on :::::::: also check to ? that the freewheel lever is in drive .good luck...

Hi if it is similar to pride x the circuit will shut down if key is left on for 20 minutes u will still have lights. Remove key for a short time then replace it & turn on ..goood luck

Download the manual from here: http://www.pridemobility.com/download.php?f=owners_manuals/us_jazzy/us_jet_3_ultra_om.pdf

Instructions are on pages 40 & 41.

BEEP CODE CONDITION SOLUTION
2 Battery voltage is too low to operate Charge the batteries fully until charger and
the scooter. any meters indicate completion.
3 Battery voltage is too high to operate Contact your authorized Pride Provider for
the scooter. assistance.
5 Solenoid brake trip. The manual freewheel Remove the key, then push the manual
lever may be in the freewheel position. freewheel lever to the drive position and
restart the scooter.
6 Throttle trip. The throttle control lever Release the throttle control lever completely,
may have been depressed while inserting then reinsert the key.
the key.
7 Throttle trip. Throttle potentiometer Contact your authorized Pride Provider for
fault or speed potentiometer fault. assistance.
8 The motor is disconnected. Contact your authorized Pride Provider for
assistance.
9 Possible controller trip. You may be Shut down your scooter for a minimum of
attempting to install the battery pack while several minutes to allow the controller to
the key is inserted or the motor controller cool. Or, try reinserting the key into the key
may be in overheat protective mode. switch.
What you may be doing is mis-counting the beeps and it may be 9 beeps or its 8 and you have a bad connection between the motor and the switch? Good luck!

You can download the service manual from Pride's website. That will tell you what the flashes mean and how to fix it.

Hi, when it stops and starts bleeping , Do you turn it off and start again or does it just go again ?,,,

Regards
Rob

www.gewizrepairs.co.uk

Your charger will not pick up the dead batteries because they were'nt made to pick up the low charge ,In this case buy new batteries and your problem should be solved.

Are you sure your charger is working? Is the free-wheel lever engaged? Also the charger has an inhibit line, it will not run when the charger is plugged in.