Turns on hear a click shuts off

I assume you are referring to the water dispenser on your GE refrigerator. To turn off the water dispenser, you can either: Press and hold the "Lock" button on the control panel until the water dispenser display turns off. This will lock all the functions of the control panel, including the water dispenser. Locate the water shut-off valve behind the refrigerator and turn it off. This will shut off the water supply to the refrigerator and disable the water dispenser. Note: If you are trying to turn off the ice dispenser, the process may vary depending on the model of your refrigerator. Some models have a separate on/off switch for the ice dispenser, while others do not allow you to turn off the ice dispenser without turning off the entire refrigerator. Please consult your owner's manual for specific instructions.

There are three things that can cause this.
A stuck water inlet valve.
Except is hums which means the solenoid is energised.
So it is either a switch that tells it to work.
Or the control board.

Unless you have a multimeter and the ability to check voltages and open circuits, call in a service tech.

https://www.google.com/search?q=Haier+fridge+with+water+dispenser+which+won%27t+turn+off

..

I would say that the motor is humming because it is not turning and the click is when the overload control switches the power off. It may be a start run capacitor blown out but it may be a seized compressor motor. have a fridge mechanic check it out.

You will need to replace the dispenser control board on the door. Here is the part to order.

If the refrigerated water light on your Haier HRF6631SB2/U fridge freezer is showing red, it could indicate a problem with the water dispenser. Here are a few things you can try to fix the issue:

1. Check the water supply: Make sure the water supply to the fridge is turned on and that the water supply valve is not closed or clogged.
2. Check the water filter: Make sure the water filter is not clogged. If the filter is dirty, replace it with a new one.
3. Check the water inlet valve: Make sure the water inlet valve is not clogged or damaged. The valve may need to be cleaned or replaced.
4. Check the water dispenser line: Make sure the water dispenser line is not clogged or frozen. If the line is frozen, defrost it.
5. Check the control board: If the above steps do not resolve the problem, the control board may be faulty and will need to be replaced.

If you are not familiar with any of these steps or if the problem persists after trying these solutions, it's best to contact the manufacturer or a professional for further assistance.

Turn the Auto-off "OFF". Press Button 3-10 seconds until off.

Hi,
There are many reasons why a dehumidifier willnot work or collect water.
Here is a tip that I wrote to help people to figure out what is going wrongwith their dehumidifier

Dehumidifier is running but no water is in bucket

heatman101

';';'
;';

You have a bad main control board . Located behind the refrig , behind an 8 X 10 " panel . Easily replaceable . Sorry , not Seabreeze . You can reach him at seabreeze appliance parts . com , I think .

first thing i would check here is my water resivoir, on these models it has a tendency to freeze,, hit the tank and upper line with a hair dryer for several minutes then give the water a try....
barring that it may be time to change your water filter even if the sensor has not picked it up yet

Solder, solder, solder! Shut down circuits protect crts to avoid permanent damage. If any of the deflection circuits are defective, or intermittent, shut down occurs. I have not only seen bad solder on deflection circuits, especially vertical, but also intermittent connections on the yokes themselves. I've also seen shorted convergence ics cause shut down. Don't forget solder connections in the power supply.