IV'E LOST MY INSTRUCTIONS AND NEED TO RESET MY CASIO WATCH AFTER A BATTERY CHANGE CAN YOU HELP

Diplodocs - CASIO: 1506 references - Your user manual immediately available! Your CASIO has four push button and one for winding button. the first button has mark of LIGHT , the below button is MODE ,,upper right START/STOP,,, lower is LAP/RESET. the center button is what they called it a CROWN to set crown is just pull it and you can set the hour and minute. the LIGHT button is the set button also, just press it for 15 seconds if dial flashes, then go to MODE button and choose what going to set, the START/STOP -- LAP/RESET is the scroll button you going up and down the number or on /off ,some model of Casio Edifice, the set is in the MODE button just press it long and if flashes it ok. and follow procedure what i said before. setting cannot damage the watch. Feel free to ask question regarding your to watch so i can assist.. Hope this may help;

Regards,
VOTIT

You can get instructions from the Casio web site.

Go to the casio web site "casio.com".

Select "support" and the "manuals",
watches;

Accept terms

Select "watch manual archive"

Read the number of the back of your watch and enter it into the search box

Your watch probably needs a reset after the battery change.
Take the back off the watch. Examine the movement carefully - you should find a small electrical contact point marked 'AC' (which could be quite small). To perform a reset you will need to temporarily connect 'AC' to the '+' terminal of the battery (basically, the upper side of the battery). If you have some fine point tweezers they are ideal, but a bent paper clip (not a plastic coated one) will do.
Be very careful not the make metal contact with any other part of the movement!
Place one end of the paper clip on the 'AC' contact and, for 3 seconds, place the other end on the battery '+'. As watches sometimes need to be reset twice, there's no harm in repeating the operation while you have the back off the watch.
Once successfully reset, you should have no problem with setup and the watch should behave normally.
Hope this helps.

If you haven't got instructions on how to do this, you can get
instructions from the Casio web site.

Go to the casio web site "casio.com".

Select "support" and the "manuals",
watches;

Accept terms

Select "watch manual archive"

Read the number of the back of your watch and enter it into the search box

If you haven't got instructions on how to do this, you can get
instructions from the Casio web site.

Go to the casio web site "casio.com".

Select "support" and the "manuals",
watches;

Accept terms

Select "watch manual archive"

Read the number of the back of your watch and enter it into the search box

If you haven't got instructions on how to do this, you can get
instructions from the Casio web site.

Go to the casio web site "casio.com".

Select "support" and the "manuals",
watches;

Accept terms

Select "watch manual archive"

Read the number of the back of your watch and enter it into the search box

You need to follow the instruction manual after changing the battery.
You can get instructions from the Casio web site.

Go to the casio web site "casio.com".

Select "support" and the "manuals", watches;

Accept terms

Select "watch manual archive"

Read the number of the back of your watch and enter it into the search box

Click on "search" and the download your instructions.

go to www.casio.co.uk go to support(methinks??) click on watches and put in the model number (the one you posted) and download the PDF manual relating to your watch (you will need adobe reader free download to read PDFs), this will be the full manual, once you figure it out DST will have to be on, as its summertime of course. ( i bought a wave ceptor for a fiver because the guy who had it didnt know how to recalibrate it after a battery change), a quick gander at the online manual put it right, there shouldnt be a problem setting it up again, good luck

Use this page to download a copy of CASIO watch manuals in PDF format. To download a PDF file, enter the four-digit (or three-digit) module number marked on the back cover of your watch.

http://world.casio.com/wat/download/en/manual/


You will need a pdf reader on your pc, you will find all instructions in there.