Konica Minolta bizhub 350 - can't network scanner

Self Help Product Support Konica Minolta Business Solutions Inc

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

1-Re-Install the imaging unit.
2-Restart the machine.

Yes, it is possible ti use Konica Minolta bizhub 210 photocopier as a network printer.For this simply purchase network card Model NC-502 for bizhub 210.

hi U must have the driver see [konica minolta sit support an driver serch for TWIN driver ] will help U

FIOS and DSL use different modems and or gateway devices. Sounds like you were using a DSL gateway device with networking setup and when you moved to FIOS, the tech did not duplicate your network on your new FIOS gateway. OR you had a 3rd party router e.g. Linksys that was removed from the setup when FIOS was installed.
Either way, Verizon is who you should contact. Just tell them your network went down after you moved from DSL to FIOS. Dont mention Microsoft or Livewebtv.

Check the driver, you should have availability.

Reset your Toners and Imaging units for Minolta Bizhub and CF series.
http://www.chipreset.eu

Your laptop is not configured properly to the network. You forgot to mentioned what type of scanning. ftp, smb, scan to email scan to box. But any way your IT can help you with this problem. If not I will email you the step by step to configure you laptop.

Set the Gateway TX to "Allow"

1. Press the Utility/Counter button.
2. Touch Admin Management
3. Enter Password (The default password is 12345678)
4. Touch Admin2
5. Touch Network Settings
6. Touch Network Settings1
7. Touch Scanner Settings
8. Touch Gateway TX
9. Set Gateway TX to Allow

Yes you need the Driver.

http://help.bt.konicaminolta.ca

You can find all the drivers and help you need there.

click here for the steps on how to configure the bizhub 350 and here for the vista driver that you need to use if you're going to install it in a vista computer

hope this'll help you

ciao