Dryer will not start cycle

Try one of these diagnostic repair videos on YouTube:

https://www.youtube.com/results?q=Whirlpool+dryer+won%27t+start+stays+on+sensing

These videos may help. Look at the one regarding dryer fuse first.
https://www.youtube.com/results?search_query=+Kenmore+HE3+dryer.++sensing

what color is your unit is. is it biscuit or color pewter or color platinum

Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor goingbad...

Here are a couple of tips that I wrote will help you to figure out why yourdryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101


'; '; ';

Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor going bad...

Here are a couple of tips that I wrote will help you to figure out why your dryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101
/////////////

Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor goingbad...

Here are a couple of tips that I wrote will help you to figure out why yourdryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101

..

Commonproblems...blown house fuse, broken belt ( on some models )...door switch...*thermal fuse open (venting needs attention )...broken or burnt wire....timer....motor, in order from mostcommon to least common. * If you find a blown thermal fuse, always clean, change, adjust the ventingsystem and vent hood first, then it is often a good idea to replace the operatingthermostat at the same time. This is a picture of some modernthermal fuses.



I hope this will solve your issue.

Good Luck

If my solution proves useful please accept it.

Regards
Arjun

chould be a fuse inside dryer its oblong white ck it but unplug dryer first

It's the thermal fuse and it's easy to install if you have a front loader just take the kick panel off in front, make sure you remove the lint filter and the cover that goes up to the lint collector and you will see the thermal fuse. Make sure you unplug before doing this. Take the two screws out of the bottom of kick panel and than use a putty knife and push down and the panel will come right off. Hope this helps you out.