Ge frig not working some times

check the touch pad or control unit any short circuit in the control unit, other wise any moisture at control unit chec the circuit other wise replace the touch pad.

Sounds like the capacitor on the dispenser circuit on the main control board has shorted out. You will need to replace the main control on the back of of the refrigerator

You have a bad main control board . Located behind the refrig , behind an 8 X 10 " panel . Easily replaceable . Sorry , not Seabreeze . You can reach him at seabreeze appliance parts . com , I think .

If it clicks then goes to standby, then the fault is in your power supply circuit. If the sound comes on then the fault is in the line timebase circuit. Aquick way to check the line circuit is to place the back of your hand about 1" from the screen as you switch on, you will feel the hairs on your hand standing to attention.

Your PTC relay is bad it protects the compressor from over heating and overloading. You need to replace it.

First be sure to unplug frig. Remove the cardboard cover that covers most backs of the frig units. Remove the plastic cover that is on the side of compressor. It is held on with a metal clip. Now you should be able to see the relay pry the relay straight off. note the wiring and position of relay. Only three prongs on compressor. Go to a parts house for appliance's and with your make and model number should be able to get a new one. Let me know if you need any more help. ken

I think you are correct that its the switch that the push bar hits is faulty. Try a serch on line for applince parts and enter you make etc. This should provide a break down of the part and a idea what is needed to take apart/off to get to it.

I had this problem with a similar refrigerator. The problem was the slide switch burns itself especially if you slide it from ice to water while holding the glass in to get ice and water into your glass. Better to slide it to ice, press the glass in to get ice, release the glass to stop the ice, slide the switch to water, then press the glass in again to get water. I "fixed" mine by removing the control panel and soldering some of the connections on the slide switch together so that we now have no crushed ice function, but the ice cubes work again. You can also replace the circuit board in the control panel to restore it to like-new operation. I could not find a place to order just the slide switch.

Not sure if this is the same problem with your unit, but sounds the same.

It sounds like the overload and relay on the compressor.If the problem isn't that then you need a compressor.

Eeggman