I don't have a password for my router D-Link DIR-300 please can u tell me how o setup a password for my router

Open your web browser and type in the IP address of the router (192.168.0.1 by default)

The default user id is: admin and the password is left blank. Once you get into the router go to the wireless setup or tab.

Below is a pdf manual of your router.

ftp://files.dlink.com.au/products/DIR-300/QuickInstallGuide/DIR-300_A1_QIG_v2.00.pdf

The default IP for the DIR-300 is 192.168.0.1. First, make sure you're entering "http://192.168.0.1" in your browser's address bar. In some browsers, if you try entering just the numbers, it won't work.

If you can't access the setup page at all, that address may have been changed. If this is the case, or you can't log in because you don't remember the username and password, you should reset the router which will restore the factory defaults.Press the recessed rear-panel reset button and hold it in for 10 seconds. Release it and the router will restart. The defualt IP (192.168.0.1) and username and password (both admin) will be restored.

Here is the manual, wireless setup is on page 25:

http://www.scribd.com/doc/18484465/DIR-300-Wireless-Router-Manual

I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309

start - run- type in cmd- enter- type in ipconfig /all will show router address should be 168.192.1.1
open internet explorer and type that # in the address bar
should connect with router
leave password blank or type in password for the password
enter the router setup and configure router to your preferance

First connect your router to computer with ethernet cable.
Then you can access it with following link
http://192.168.1.1
or
http://192.168.0.1
type user as "admin" and password as "admin" or blank or "password"
then go to wi fi security set your WEP code it is your password to connect wi fi network.

Let me know if you need more assistanse.
Thanks

you don't need to install a router on a PC. The wireless card or ethernet cable should talk to the router.

You can download the manual at

ftp://files.dlink.com.au/.../DIR-300/Manuals/DIR-300_Manual_v1.00.pdf

Section 3 leads you through the setup.

Yes, you can reset the password on your D-Link DIR-300 router. To do this, follow these general steps:

Access Router Settings:

Connect your computer to the router either via a wired or wireless connection.
Launch a web browser and input the IP address of the router (frequently 192.168.0.1 or 192.168.1.1) into the browser's address bar.

Login:

Enter the router's username and password. The default credentials are often admin/admin.

Navigate to Password Settings:

Look for the "Setup," "Wireless," or "Security" tab in the router settings.
Find the section related to changing or resetting the password.

Reset Password:

Follow the on-screen instructions to reset the password.
You may be asked to enter the old password before creating a new one.

Save Changes:

Save the changes and reboot the router if required.
Please note that the exact steps may vary slightly based on the router model and firmware version.
If you Need More Router Support visit: Geek Squad Assists.

i do not have wep option in my wireless settings

u have to setup as wep
then enable secure network then set encryption key.wihc is prompt for connect network.