My oven works fine when cooking, but after the oven is shut off I get a f1 error.
Dacor cps130 wall oven f1 error:
I am getting an F1 Error and the oven beeps pretty much every 30 seconds. Please help.
According to the manual, this is an element relay circuit failure. Call the tech.
Oh, here are the other codes:
F0 Touch pad stuck in depressed position
F1 Element relay circuit failure
F2 Oven temp exceeded the clean runaway temp (self clean) -or- runaway temp (cooking modes)
F3 Short circuit in oven temp sensor
F4 Open circuit in oven temp sensor
No F5
F6 Failure in the EEPROM check comparison (only time of day and timer will operate)
F7 Failure of Self-Clean auto door latch circuit
F8 Failure of the door latch motor. Occurs when the motor runs for two minutes without the door locking Self-Clean mode.
×
2,649 views
Usually answered in minutes!
the oven reads off. we were trying to figure out how get turned back on when my husband somehow got the lower oven to revert to the f1 mode and it is beeping.
I was using the upper oven at 350, I finished cooking, turned off the oven then the lower oven controls started beeping with a f1 error. ???? We were not using the lower oven.
Same issue as others. We all of a sudden started getting the F1 error when the oven is not in use. The beeping is constant. We are now forced to turn off the circuit breaker when not using the oven. Please help.
My oven did the same thing, but we hadn't used our oven in about a week when all of a sudden it started beeping.
I was doing the dishes and noticed the oven fan going... checked and it was on, there was nothing on the panel to indicate it was on. Pressed on cancel and the F1 error came on. We couldn't get it to go off, we had to turn the circuit off????????????????
I HAVE TO DISCONNECT THE OVEN, TURN OFF POWER FROM BREAKER BOX. WHEN POWER IS RESTORED ; AFTER ABOUT 1-2 MINS IT WILL START BEEPING AND SHOWING A f-1 ERROR MSG.
I have the same problem; I suspect some water got into the circuitry behind the touch panel; our oven is mounted underneath a countertop, and water occasionally drips down.
I have a similar problem with my RSD30 model floor standing model. I replaced the relay board at a cost a cost of $200 for the part and the problem still exits. I have not seen a solution for this yet so I may have to call for a service call.
I have a dacor convention plus wall oven that did not seem to shut off, the repairguy said I need a new control board. Is he correct and approx. what should it cost, and where can I get a good dealfrom a reliable source?
The oven is a Dacor Pure Convection Wall Oven. Oven door will not open all the way, it binds at 75 degrees opening. Also the door is not tight against the oven when in the closed position
F1 ERROR
×