Temp. too hot .Where can i find the temp. control? thanks

sounds like the control head is bad replace control head

its basicaly an electric switch that tells doors in your dash to let either hot or cold air in. if you havev no control over heat or cool air your going to have to replace the control unit. junkyard would be your best bet on a budget

possible blend air door motor stuck, try tapping lightly on the servo motor while moving the temp selector from hot to cold,

Make sure the hoses are connected correctly to the water valve on the machine. The connections will be marked with an "H" and a "C".

Given they are correct, most current washing machines have and auto temp feature on the water fill. It allows even cold water settings to bring in some hot water to make sure the water temp is hot enough to efficiently disolve your laundry detergant. The preset temps are usually around 75* for cold, and 105* for warm. Hot water comes in at whatever temp your household water temp is.

the climate unit has an internal fault

Check the temp-controler, if the system is charged properly, then an acculator is not needed.

if you have the owners manual, look it up in the manual...if not, do you prefer to be basted?..lol

All heaters have controls, you just gotta find it

Thanks for using fixya.com

Replace the temp control on this car, it should be electrical control not cables.

more than likely if it isnt shutting off when it reaches temp. then it probably needs a temp sensor or a EOC (electronic oven control). I have replaced many of these boards in the past , usually there is a relay on the board that is stuck. The relay really isn't replaceable and the whole board needs to be replaced. Does the dispay show the temp that the oven acually is or the temp it is set for?

hi try to just regulate the temp by turning down the water flow from your taps if more cold is coming in than hot turn cold water down a bit to your satisfaction thanks THE APPLIANCE DOC