2019 honda goldwing cb radio does not transmit - TX light comes on - CB radio does receive transmissions from other cb radios

SOURCE: my galaxy 959 cb radio wil not put out any transmit

Hi,

Based on your post of no transmit, a couple of possibilities:
1. defective microphone or cord or PTT switch (the red TX light does not come on when pressed);
2. TX light comes on but no output, defective finals and/or drivers. These are the transistors screwed to the chassis of the radio very near the antenna terminal;
3. defective regulator IC that provides the TX B+;
5. insufficient amperage from you power supply;
6. too high SWR.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.

SOURCE: Have Cobra 29 LTD CB

Sounds like the PLL circuit....... no channel synthesizer will kill the transmit and receive...... bad crystal or IC could be at fault or if someone has attempted to add more channels could also be cause.

SOURCE: CB Radio on 2003 Honda Goldwing quits working

i would ck all plug in wires under seat if there ok ckplug in wire under right side lock glove box

SOURCE: CB Radio will receive but not transmit

Sound Like The Modulation Amp May Be Dead..
Or a Componet in The Mod. Section....You Can Pick up The Repair Manual..@ www.samswebsite.com For about $20.00...Good Luck

SOURCE: No audio Transmit

Try a hand mic with the set, there may be a short within the radio.If not your problem is with the audio amp in the radio itself.Repair should be about $15.00.