Question about Homelite Garden

1 Answer

My homelite weed eater idles to high - Homelite Garden

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Homelite Master
  • 85,161 Answers

Posted on Jul 27, 2018

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
trippssmengi
  • 76 Answers

SOURCE: Homelite

Go to www.homelite.com then in the red up top click on order parts then click launch to parts catalog then scroll down to accept agreement and then you will need to enter your model # and then you can go thru the list of breakdowns and get your part # from the diagrams.

Posted on Jan 05, 2009

scott586
  • 41 Answers

SOURCE: Weed eater GTI 17 won't run on high speed

A couple of things may work...
Make sure you have the correct Oil / Fuel mixture, if it is incorrect the motor may have problems running.
Also take off the bottom where the cord is wound up, make sure there hasn't been any grass get wound up inside it, this will cause it to stall out on high RPM.

Posted on May 19, 2009

carlsbiz
  • 1124 Answers

SOURCE: weed eater stalling

Need to get the carb rebuilt..

Posted on Jul 14, 2009

  • 112 Answers

SOURCE: gas weed eater pull cord wont retract after pulling cord

remove the cover and the screw holding the recoil down, turning the pulley ccw should release the spring then wind rope around pulley and (hopefully yours has the slot in it) wind in the direction of the pulley teeth then, holding rope in slot put back on spring and wind cw till almost tight, and install screw. Usually you can do this without taking rope handle off. sometimes you have to remove handle. look at spring end in the middle and make sure its not broke as long as you have it apart. Its a easy fix.
Thanks for using fixya

Posted on Jul 25, 2009

  • 127 Answers

SOURCE: My Ryobi weed eater loses power at working speed after 5 minutes.

you need to replace fuel filter inside the fuel tank . fish it out with and empty tank using a coat hanger and a small hood bent on the end.filters are around $9.00

Posted on Aug 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

A friend of mine gave me a zr series ,625cdv homelite weed eater and I can't figure out how to adjust the carb. Bought a new primer bulb it crank and run for a little bit but I have to idle it high


Screw in the HIGH and LOW needle valves. Then turn each one out 1 full turn, That should be a good starting point.
After engine is running Run engine at Full throttle. Loosen HIGH screw until the engines RPM slows a bit. When that happens Turn screw back in until it revs high and then just starts to slow again. You do not want the engine to run at it's highest RPM or it's not getting enough Lubrication It need to run Rich, that's why you screw the screw in a bit after the engine has reached it's highest RPM. Let it idle down . Then Accelerate hard, if it hesitates, loosen or tighten the LOW until it accelerates quickly with no hesitation.

May 30, 2017 | Homelite Garden

1 Answer

Lost manual does this weed eater take regular gas or is it a mix


Want to give us a hint as to what kind of weed Eater this is? Most gas models use a mixture but the ratio can vary between manufacturers.

Jan 08, 2015 | Homelite Garden

1 Answer

Weedeater and Homelite shafts interchangeable?


Just give it a try. Some different brands will interchange. I have done this with a Toro and it is still running.

May 18, 2014 | Homelite Garden

1 Answer

What is the gas to oil ratio for weed eaters?


Most gas weed eaters use 2-cycle engines. For the Homelite 2-cycle engine trimmers, use a 50:1 ratio of gasoline to the Homelite lubricant. (For 1 gallon of gas, add 2.6 oz of the oil.)

Many Homelite tool manuals are available here: http://www.homelite.com/service_support/product_owners_manuals . Scroll down to find your string trimmer.

I hope this helps.

Cindy Wells

Jul 16, 2011 | Homelite Garden

1 Answer

Need to know the gas ratio to use in a homelite(trimlitr) weed eater.


50:1 if that is too rich the weed eater will give off white smoke then use 30:1

Jun 18, 2011 | Homelite Mighty Lite Lawn Trimmer

1 Answer

I was given 2 weed eaters, the z830sb, and the d630cd. I need to know what the gas and oil mixtures are for these units.. Thanks Jim


32:1 should be a good mixture for the homelite weed eaters. here is a thread on it, hope it helped Tim:

ttp://forums2.gardenweb.com/forums/load/tools/msg1011591014681.html?13

Apr 24, 2011 | Homelite Mighty Lite Lawn Trimmer

Not finding what you are looking for?
Garden Logo

Related Topics:

66 people viewed this question

Ask a Question

Usually answered in minutes!

Top Homelite Garden Experts

roeb

Level 3 Expert

819 Answers

Jay Finke
Jay Finke

Level 3 Expert

1389 Answers

Randy Schumann
Randy Schumann

Level 2 Expert

407 Answers

Are you a Homelite Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...