Tunturi C425i adjustments - Tunturi Exercise & Fitness

Question edited for clarity.

Parts suppliers.

https://www.google.com/search?q=t+r701+tunturi+rowing+machine+replacement+springs

Manual

Tunturi R701 Owner's Manual - ManualsLib

ManualsLib https://www.manualslib.com > ... > Home Gym > R701
View and Download Tunturi R701 owner's manual online. Tunturi Air Rower Owner's Manual. R701 home gym pdf manual download.

Hi,

Please check with Mcmaster carr, ebay and amazon to find your treadmill part. You can also check out alibaba if the 3 prior sources don't work out for you.

Thank you.

We don't have anything. We are FIXYA dot com, we are not Tunturi. Parts seem to be no existent for this make and model. I remember I had Puch Tunturi exercise bikes at a newly opened sports centre in Dunstable, England in 1975!

https://www.gymparts.co.uk/browse/parts-for-tunturi/c03408

https://www.partsfortreadmill.com/catalogsearch/result/?q=T40

https://www.google.com/search?q=Tunturi+T40+parts

..

You'll find the battery acid has leaked on the green cable linking the console to the buttons. I wiped down this green cable with water - removing the acid residue and the buttons started working again.

You can get to this cable by unscrewing the plastic fascia. There are six screws on the rear and two on the base of the unit.

Seb

Download: www.manualslib.com/manual/184017/Tunturi-C35 for how to get the owner's manual. If your cross trainer is anything like mine there are joints all over the place to be adjusted and tightened and lubricated all the time. THe clunking can be from any or all of them....check each joint for excessive play and adjust to a reasonable tension.

Dear Sir:You must RUN the software calibration for easy diagnose, troubleshooting, and fix it. After that you need adjust the speed sensor, see the diagram attached, clean, and tight the connector very well. Then you can lube the gear and shaft from elevation motor b) adjust the potentiometer c) test the elevation motor. But first RUN s. callibration.
sincerely. God bless you

RUN THE SOFTWARE CALIBRATION FOR DIAGNOSE, TROUBLESHOOTING AND FIX IT.

2) you can lube the gear, shaft+ adjust the potentiometer+see the relais contact are clean it.

sincerely. God bless you

Dear Sir:

This error is indicating the elevation motor is overspeed.

Adjust the sensor speed see the diagram , and then Run the Software calibration for easy diagnose and troubleshooting.

See my personal TIPS, for diagnose and troubleshooting.

sincerely. God bless you.

ernesto cuadra
managua, nicaragua. c.a.

Dear Sir:

Please adjust the sensor speed , see the diagram below 2) Tigh the wires from the sensor speed 3) Run the sotware CALIBRATION very IMPORTANT! for easy diagnose and troubleshooting

sincerely. God bless you.

ernesto cuadra
managua, nicaragua. c.a.

http://www.youtube.com/watch?v=TquYcOzGIw4&feature=related
http://www.youtube.com/watch?v=9G4MZh8JO2Q
http://www.youtube.com/watch?v=M7qJrRbdfBc
http://www.youtube.com/watch?v=MIIxoPtvhy8hthttp://www.fixya.com/support/r10724803-measure_voltage_in_transforme_fitnesshttp://www.youtube.com/watch?v=bF3OyQ3HwfU&feature=related